www.desatech.com111515-01J 17INSTALLATIONContinued3.. Place.left.front.log.(log.#3).on.grate.prongs.as shown in Figure 22, page 16.4.. Place.right.front.log.(log.#4).on.peg.of.log.#3.and.grate.prongs.as.shown.in.Figure.22, page 16.5.. Place.left.crossover.log.(log.#5).on.pegs.of.log.#.and.#3.(see.Figure.3)..Place.middle.crossover.log.(log.#6).on.pegs.of.log.#1.and.#.(see.Figure.3)..Place.right.crossover.log.(log.#7).on.pegs.of.log.#.and.#4.(see.Figure.3).6.. Slide. control. cover. log. (log. #8). into.place.between.front.logs.#3.and.#4.(see.Figure.4).Figure 23 - Placement of Crossover Logs(Logs #5, #6, and #7)Log.#5Log.#6Log.#7Figure 24 - Control Cover Log (Log #8)PlacementLog.#8OPERATIONFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which mustbe lighted by hand. When lightingthe pilot, follow these instructionsexactly.B. BEFORE LIGHTING smell all aroundthe appliance area for gas. Be sure tosmell next to the floor because somegas is heavier than air and will settleon the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; donot use any phone in your building.• Immediately call your gas supplierfrom a neighbor’s phone. Follow thegas supplier’s instructions.• If you cannot reach your gas supplier,call the fire department.C. Use only your hand to push in or turnthe gas control knob. Never use tools.If the knob will not push in or turn byhand, don’t try to repair it, call a quali-fied service technician or gas supplier.Force or attempted repair may result ina fire or explosion.D. Do not use this appliance if any parthas been under water. Immediatelycall a qualified service technician toinspect the appliance and to replaceany part of the control system andany gas control which has been underwater.