Desa LDL3924PR Owner's Operation And Installation Manual

Also see for LDL3924NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Desa LDL3924PR Owner's Operation And Installation Manual Manual pdf 16 page image

111515-01CFor more information, visit www.desatech.comFor more information, visit www.desatech.com16HAND-HELDREMOTE OPERATIONNOTICE: You must light the pilot before using thehand-held remote control unit. SeeLighting Instruc-tions, page 15.Shutting Off HeaterPress on/off key on remote control and turn control knobclockwise to the OFF position (see Figure 25, page 15).Shutting Off Burners Only (pilot stays lit)Press the on/off key on remote control or turn control knobclockwise to the PILOT position.TO TURN OFF GASTO APPLIANCEMANUAL LIGHTINGPROCEDURE1. Follow steps 1 through 7 under Lighting Instructions,page 15.2. Depress control knob and light pilot with match.3. Keep control knob pressed in for 30 seconds after lightingpilot. After 30 seconds, release control knob. Now follow steps9 through 11 under Lighting Instructions in column 1.CAUTION: Do not try to adjust heating levels byusing the equipment shutoff valve.Figure 27 - Pilot (Propane/LP)IgnitorElectrodePilot BurnerFigure 28 - Pilot (Natural)IgnitorElectrodePilot BurnerNote: The pilot flame on natural gas units will have a slight curve,but flame should be blue and have no yellow or orange color.OPERATING HEATERContinuedOPERATING HEATERLighting Instructions (Cont.)To Turn Off Gas To ApplianceManual Lighting ProcedureHand-Held Remote Operation8. With control knob pressed in, press and release ignitor but-ton. This will light pilot. The pilot is attached to the rear ofthe front burner. If needed, keep pressing ignitor button untilpilot lights.Note: If pilot does not stay lit, contact a qualified serviceperson or gas supplier for repairs. Until repairs are made,light pilot with match. To light pilot with match, see ManualLighting Procedure.9. Keep control knob pressed in for 30 seconds after lightingpilot. After 30 seconds, release control knob.• If control knob does not pop out when released, contacta qualified service person or gas supplier for repairs.Note: If pilot goes out, repeat steps 4 through 8.10. Slightly push in and turn control knob counterclockwiseto the ON position.11. Press the on/off key on the remote control to turn on appli-ance main burner. Wait at least 5 seconds before settingdesired flame height.12. Press the up or down key until the small triangle is to the leftof large flame icon at the top of LCD display (see Figure 29).Press the left or right key to set the desired flame height.13. Replace control cover log (see Figure 26, page 15).When the appliance and the remote control are switched off, thehouse icon with the room temperature will be displayed. Whenthe remote control is turned on, other icons will be visible andthe main burner of the appliance will turn on.1. Turn control knob clockwise to the ON position(see Figure 25, page 15).2. Press the ON button on remote control (see Figure 29). Wait5 seconds to send a command to appliance.Note: An acoustic signal will be heard that confirms the recep-tion of the command sent from the remote control.Left and RightKeys Increaseand DecreaseSet PointsOn/Off ButtonFlame HeightIndicatorThermometerIconClock IconFigure 29 - Remote ControlLCD DisplayRoomTemperatureDisplay(°F or °C)Sleep TimerDisplayUp and DownKeys SelectAvailableFunctionsLock-OutIndicatorLow BatteryIndicatorSmall TriangleIcon (FunctionIndicator)