Desa LMFP33NR Owner's Operation And Installation Manual

Also see for LMFP33NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa LMFP33NR Owner's Operation And Installation Manual Manual pdf 9 page image

www.desatech.com111604-01E 9Figure 6 - Assembling Brass TrimSide BrassTrimSlotMiteredEdgeSlotShimSet ScrewsAdjustingPlateTrimHangingScrewsAssembledBrass TrimHangingNotcheson TrimASSEMBLING AND ATTACHINGOPTIONAL BRASS TRIM(Included with Mantel Accessory)IMPORTANT: If you are recessing the firebox in awall, do not attach brass trim at this time. See page 10.Note: The instructions below show assemblingand attaching brass trim to fireplace.1. Remove packaging from three pieces of brass trim.2. Locate four brass screws, two adjusting plates withset screws, and two shims in the hardware packet.3. Align shim under adjusting plate as shown inFigure 6.4. Slide one end of adjusting plate/shim in slot onmitered edge of top brass trim (see Figure 6).5. Slide other end of adjusting plate/shim in slot onmitered edge of side brass trim (see Figure 6).6. While firmly holding edges of brass trim to-gether, tighten both set screws on the adjust-ing plate with slotted screwdriver.7. Repeat steps 1 through 6 for other side.8. Tighten trim hanging screws (#10 x 6.25 shoul-der) into holes in cabinets. Place the assembledtrim onto fireplace cabinet. Align hanging notcheson trim with hanging screws on side of fireplace(see Figure 7). Push trim firmly into place, slid-ing hanging notches over hanging screws.Top BrassTrimINSTALLATIONContinuedFigure 7 - Attaching Brass Trim toFireplaceINSTALLATION CLEARANCESWARNING: Maintain theminimum clearances. If you can,provide greater clearances fromfloor, ceiling, and adjoining wall.Carefully follow the instructions below. This willensure safe installation.Minimum Clearances For SideCombustible Material, Side Wall, andCeilingA. Clearances from the side of the fireplace cabi-net to any combustible material and wallshould follow diagram in Figure 8.Example: The face of a mantel, bookshelf, etc.is made of combustible material and protrudes3 1 /2" from the wall. This combustible mate-rial must be 4" from the side of the fireplaceopening (see Figure 8).B. Clearances from the top of the fireplace openingto the ceiling should not be less than 42 inches.*ExampleMINIMUM CLEARANCE TOCOMBUSTIBLE MATERIALSTop Left and BottomRight Sides and Rear42" 16" 0"Figure 8 - Minimum Clearance forCombustible to Wall*Minimum 16 inches from Side Wall