Desa M42E Installation Manual

Also see for M36E: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa M42E Installation Manual Manual pdf 20 page image

10879620For more information, visit www.desatech.comFor more information, visit www.desatech.comTROUBLESHOOTING The two most common causes of a malfunctioning gas appliance are:1. Loose wiring connections2. Construction debris clogging the pilot and/or gas control valve filterOBSERVED PROBLEMIgnitor will not spark or pilot will not lightPilot will not stay litNo gas to burner, although wall switch andvalve are set to the ON positionFrequent pilot outagePOSSIBLE CAUSE1. No gas supply, or shutoff valve is OFF2. Air in gas line3. Construction debris clogging pilot orifice4. Low gas pressure5. Kinked pilot line6. Control valve knob is not opening7. No power to unit or the ignition moduleor power transformer is bad8. Vent damper not fully open1. Loose wiring on ignitor wire to ignitionmodule and/or poor ground to ignitionmodule2. Pilot flame too low to sense1. Wall switch wires defective or too long2. Thermopile not generating sufficientvoltage1. Pilot flame may be too low, causingsafety pilot to “drop out”2. Improper venting or excessive blockageREMEDY1. Check to see if you have gas supply andthat equipment shutoff valve is opened2. Repeat lighting procedure several timesto purge all air out of lines. If after re-peated attempts appliance does not light,call for qualified service and repair.3. Remove debris and dirt, inspect andclean any other possible obstructions4. Contact your gas supplier to checkpressure5. Have a qualified technician replace pi-lot line6. Replace control valve (Refer to Replace-ment Parts, page 19)7. Check that main power is on and that allwire connections are made correctly tothe ignition model (see Wiring Diagram,page 19). Check for 24 VAC at the sec-ondary side of the transformer. If 24VAC is present, and the module does notoporate, have the module replaced oth-erwise have the transformer replaced.8. Open vent damper until fully locked inOPEN position1. Check wiring connection. Refer to wir-ing diagram (see Wiring Diagram, page19) and/or check ground wire to igni-tion module2. Clean and adjust pilot burner and checkgas supply and inlet pressure to unitNote: Have a qualified technician replacepilot assembly if broken or corroded1. Check electrical connections2. Recheck problems 1 and 21. Clean and adjust pilot flame for maximumflame impingement on thermopile2. Have the vent system inspected, includ-ing the termination cap. Remove anyrestriction or obstructionNote: For additional help, visit DESA International’s technicalservice web site at www.desatech.com.Note: Before troubleshooting the system, make sure the gas shutoffvalve is ON.TROUBLESHOOTING