Desa MSVFBP Owner's Operation And Installation Manual

Contents

Desa MSVFBP Owner's Operation And Installation Manual Manual pdf 8 page image

8105986VENT-FREE PROPANE/LP GAS STOVE HEATERSUN VALLEY STOVE COMPANYFor more information, visit www.desatech.comINSTALLATIONContinuedFigure 6 - Laying Down Stove On SideFront ofStove UnitPallet WoodBolted toStove BodyBottomTop of Stove UnitFront ofStove Unit Top ofStoveUnitDrop Cloth/BlanketFigure 7 - Removing Pallet Wood From The Bottom of The StovePalletWoodBolt PalletWoodBottom OfStove UnitFrontFigure 8 - Locating Threaded Holes for Stove Bottom, Legs, and Door Attachment(Appearance May Vary Depending on Model)LegHoleLegHoleLegHoleLegHoleDoor Hinge StepBolt HoleDoor Catch BoltWith AdjustableHex Nuts HoleStoveBottomHoleFrontBottom OfStove UnitSTOVE CAVITY ASSEMBLY1. Lift off corrugated box enclosing stovebody crating.2. Remove all screws fastening the woodframe enclosure. Spread wood frame openand lift away from plastic-bagged stovebody. The bottom pieces of pallet woodwill remain bolted to the stove body.3. Remove plastic bag from stove body.4. Remove back panel from stove (seeFigure 5). Use an adjustable wrench ora 10 mm socket. Remove six (6) boltsand washers. Keep bolts and washersto reattach back panel later.5. Remove all contents from inside stovecavity. Contents include:(1) - Stove bottom(4) - Legs (include leg leveler bolts)(1) - Bottom door(1) - Top grate(1) - Hardware kit bag with fasteners6. Carefully lay stove body on back to at-tach bottom components to stove body(see Figure 6). Rest stove on drop cloth orblanket to avoid scratching stove edges.7. Remove remaining pallet wood attachedto bottom of stove body (see Figure 7).Use an adjustable wrench to remove bolts.Figure 5 - Removing Back PanelBolt ProductIdentificationLabelBackStovePanelCAUTION: Cast iron is brittle.Do not overtighten bolts orscrews during assemlby.8. Fasten each leg to stove with four (4)M8 x 1.25 - 20mm bolts. Use a flatwasher and lock washer with each bolt.Tighten bolts into threaded holes onstove body (see Figure 8, this page, andFigure 9 on page 9). Use an adjustablewrench or a 12mm socket.9. Fasten stove bottom to stove with four(4) M6 x 1 - 25mm bolts. Use a flatwasher and lock washer with each bolt.Tighten bolts into threaded holes onstove body (see Figure 8, this page andFigure 10 on page 9). Use an adjust-able wrench or a 10mm socket.