4101308PRODUCTIDENTIFICATIONFront LogControl KnobFigure 1 - Vent-Free Gas Log HeaterPiezoIgnitorFrontBurnerRear LogRear BurnerLeft FrontBranchRight FrontBranchBase AssemblyLOCAL CODES Install and use heater with care. Follow all local codes. In the absence of localcodes, use the latest edition of The National Fuel Gas Code ANSI Z223, alsoknown as NFPA 54*.*Available from: American National Standards Institute, Inc.1430 BroadwayNew York, NY 10018National Fire Protection Association, Inc.Batterymarch ParkQuincy, MA 02269Note: Where listed vented decorative logs are required, thermostat operation is notpermitted.OperationThis heater is clean burning. It requires no outside venting. There is no heat loss out avent or up a chimney. Heat is generated by both realistic flames and glowing coals. Thisheater is designed for vent-free operation with flue damper closed. State and localcodes in some areas prohibit the use of vent-free heaters. You can operate heater as avented product by opening flue damper.Safety DeviceThis heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS).The ODS/pilot is a required feature for vent-free room heaters. The ODS/pilot shutsoff the heater if there is not enough fresh air.Piezo Ignition SystemThis heater has a piezo ignitor. This system requires no matches, batteries, or othersources to light heater.1. Remove logs and heater base assembly from carton.Note: Do not pick up heaterbase assembly by burners. This could damage heater. Always handle baseassembly by grate.2. Remove all protective packaging applied to logs and heater for shipment.3. Check all items for any shipping damage. If damaged, promptly inform dealerwhere you bought heater.UNPACKINGPRODUCTFEATURESCrossover Log