Desa O36NRA Owner's Operation And Installation Manual

Contents

www.desatech.com124868-01A 11INSTALLATIONContinuedFigure 14 - Placement of Embers2. Place individual embers on their edge (notflat) along the top of burner pan. This aidsin directing flames from the burner throughember bed.Note: Too many embers or embers placedflat along burner pan can suppress theflames.3. When unit is lit, check flames for randomappearance and ember bed glowing red-orange in color (see Burner Flame Pattern,page 13). If this is not happening, eitheradd, remove or reposition loose embers.IMPORTANT: Turn unit off and let coolbefore repositioning loose embers.OPERATIONFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: Keep flue openwhen operating unit.WARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which mustbe lighted with a piezo ignitor. Whenlightning the pilot, follow these instruc-tions exactly.b. bEFORE LIGHTING smell all aroundthe appliance area for gas. be sure tosmell next to the floor because somegas is heavier than air and will settleon the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; donot use any phone in your building.• Immediately call your gas supplierfrom a neighbor’s phone. Follow thegas supplier’s instructions.• If you cannot reach your gas supplier,call the fire department.C. Use only your hand to push in or turngas control knob. Never use tools. Ifthe knob will not push in or turn byhand, do not try to repair it, call a quali-fied technician. Force or attemptedrepair may result in a fire.D. Do not use this appliance if any parthas been under water. Immediatelycall a qualified service technician toinspect the appliance and to replaceany part of the control system andany gas control which has been underwater.LIGHTINGINSTRUCTIONS1. STOP! Read the safety information,above.2. Make sure switch is in the OFF position.3. Be sure gas line shut-off valve is OPEN.4. Press in and turn control knob clock-wise to the OFF position (seeFigure 15).Note: Knob cannot be turned from PILOTto OFF unless knob is pushed in slightly.DO NOT FORCE.5. Wait five (5) minutes to clear out any gas.If you then smell gas, STOP! Follow "B" inthe safety information in column 1. If youdon't smell gas, go on the next step.6. Press in and turn control knob counter-clockwise to the PILOT position.Press in control knob for five (5) seconds(see Figure 15).Figure 15 - Setting Control KnobsPiezoIgnitorControlKnobFlame Adjustment Knob