Desa REM10PT Owner's Operation And Installation Manual

Also see for REM10PT: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

110373-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com10OPERATING HEATERContinuedOPERATING HEATERLighting InstructionsTo Turn Off Gas To ApplianceThermostat Control OperationManual Lighting ProcedureCAUTION: Do not try to adjust heating levels byusing the equipment shutoff valve.Figure 16 - Control Knob In The OFF PositionPILOTLOOFFHIIGNITORIgnitor Button Control KnobFigure 17 - PilotTO TURN OFF GASTO APPLIANCEShutting Off Heater1. Turn control knob clockwise to the OFF position.2. Turn off all electric power to the appliance if service is tobe performed.Shutting Off Burner Only (pilot stays lit)Turn control knob clockwise to the PILOT position.1. Remove front panel (see Figure 8, page 5).2. Follow steps 1 through 5 under Lighting Instructions, page 9.3. With control knob pressed in, strike match. Hold match topilot until pilot lights.4. Keep control knob pressed in for 30 seconds after lightingpilot. After 30 seconds, release control knob. Follow step 8under Lighting Instructions.5. Replace front panel.THERMOSTAT CONTROLOPERATIONThe thermostatic control used on these models differs from stan-dard thermostats. Standard thermostats simply turn on and off theburner. The thermostat used on this heater senses the roomtemperature. The thermostat adjusts the amount of gas flow to theburner. This increases or decreases the burner flame height. Attimes the room may exceed the set temperature. If so, the burnerwill shut off. The burner will cycle back on when room temperaturedrops below the set temperature. The control knob can be set to anyheat level between HI and LO. Selecting the HI setting will cause theburner to remain fully on without modulating down in most cases.Note: The thermostat sensing bulb measures the temperatureof air near the heater cabinet. This may not always agree withroom temperature (depending on housing construction, instal-lation location, room size, open air temperatures, etc.). Fre-quent use of your heater will let you determine your owncomfort levels.MANUAL LIGHTINGPROCEDUREIgnitor ElectrodePilot BurnerThermocouple6. With control knob pressed in, push down and release igni-tor button. This will light pilot. The pilot is attached to thefront of burner. The pilot can be seen through the glass panel.If needed, keep pressing ignitor button until pilot lights.Note: If pilot does not stay lit, refer to Troubleshooting,pages 13 through 15. Also contact a qualified service per-son or gas supplier for repairs. Until repairs are made, lightpilot with match. To light pilot with match, see ManualLighting Procedure.7. Keep control knob pressed in for 30 seconds after lightingpilot. After 30 seconds, release control knob.• If control knob does not pop up when released, contact aqualified service person or gas supplier for repairs.Note: If pilot goes out, repeat steps 3 through 7. This heaterhas a safety interlock system. Wait one (1) minute beforelighting pilot again.8. Turn control knob counterclockwise to desiredheating level. The main burner should light. Set controlknob to any heat level between HI and LO.