Desa RLP30A Owner's Manual

Also see for 35-FAC: Owner's manual Owner's manual

Contents

Desa RLP30A Owner's Manual Manual pdf 9 page image

www.desatech.com113855-01D 9Figure 12 - Clearance Between IgnitorElectrode and Target PlateIgnitor ElectrodeGapAreaSPeCIFICatIONS30,000 BTU MODELS• 30,000 BTU/Hr Output Rating• Fuel: Propane Vapor• Fuel Consumption/Hour:0.33 gal (1.25 liter), 1.4 lb (0.63 kg)• Supply Pressure To Regulator:Minimum* 20 psi, Maximum Tank Pressureor 200 psi• Regulator Outlet Pressure: 10 PSI• Manifold Pressure: 10.1 PSI• Hot Air Output (CFM Approx): 100• Motor: 3045 RPM, 1/40 HP• Electric Input: 120 volt/60 hertz• Amperage: 0.6• Ignition: Manual, Piezo• Temperature Range for Heater Operation:0° F to 85° F** (-17° C to 29.4° C**)35,000 BTU MODELS• 35,000 BTU/Hr Output Rating• Fuel: Propane Vapor• Fuel Consumption/Hour:0.38 gal (1.44 liter), 1.62 lb (0.74 kg)• Supply Pressure To Regulator:Minimum* 20 psi, Maximum Tank Pressureor 200 psi• Regulator Outlet Pressure: 10 PSI• Manifold Pressure: 10 PSI• Hot Air Output (CFM Approx): 100• Motor: 3045 RPM, 1/40 HP• Electric Input: 120 volt/60 hertz• Amperage: 0.6• Ignition: Manual, Piezo• Temperature Range for Heater Operation:0° F to 85° F** (-17° C to 29.4° C**)40,000 BTU MODELS• 40,000 BTU/Hr Output Rating• Fuel: Propane Vapor• Fuel Consumption/Hour:0.44 gal (1.65 liter), 1.86 lb (0.84 kg)• Supply Pressure To RegulatorMinimum* 20 psi, Maximum Tank Pressureor 200 psi• Regulator Outlet Pressure: 10 PSI• Manifold Pressure: 10 PSI• Hot Air Output (CFM Approx): 100• Motor: 3045 RPM, 1/40 HP• Electric Input: 120 volt/60 hertz• Amperage: 0.6• Ignition: Manual, Piezo• Temperature Range for Heater Operation:0° F to 85° F** (-17° C to 29.4° C)*** For purposes of input adjustment** When running heater in temperatures above 85° F(29.44° C), high internal temperatures may cause thermallimit device to shut down heater.5. Install new ignitor. Attach ignitor to rearhead with ignitor mounting screw.6. Run ignitor wire from new ignitor throughnotch in filler panel. Attach ignitor wire topiezo ignitor.7. Set gap between ignitor electrode and targetplate to 0.17" (43.18 cm) (see Figure 12).WARNING: Make sure heateris disconnected from propanesupply. Heater could ignite caus-ing severe burns.8. Test for spark. Push piezo ignitor buttonand watch for spark between ignitor elec-trode and target plate.9. Place motor and fan guard into rear ofheater shell (see Motor, page 8, steps 9and 10).SerVICe PrOCeDureSContinued