Desa SDVBNC Owner's Operation And Installation Manual

Also see for PSCIVFC Series: OWNER'S OPERATION AND INSTALLATION MANUAL

107304-01DFor more information, visit www.desatech.comFor more information, visit www.desatech.com556"4"Front4"36"fromFront42"CeilingFloorfromBackWall29"4"4"Figure 3 - Clearances for Standard InstallationFigure 4 - Clearance for Corner InstallationFigure 5 - Stove With Burner System Bottom Dimensions26 1/ 4"19 1/ 2"Front3. Proper clearances must be maintained, see Figures 3 and 4.4. This stove is a freestanding unit designed to set directly on thefloor. If your stove is to be installed directly on carpeting, vi-nyl tile, or any combustible material other than wood, it mustbe installed on a metal or wood panel extending the full widthand depth of the stove. See Figure 5.PRE-INSTALLATIONPREPARATIONContinuedSTOVE BODY ASSEMBLY1. Lift off corrugated box enclosing stove body crating.2. Remove all screws fastening the wood frame enclosure. Spreadwood frame open and lift away from plastic-bagged stove body.The bottom pieces of pallet wood will remain bolted to thestove body.3. Remove plastic bag from stove body.4. Locate the product identification label on the back panel (seeFigure 6) and record the model number and 7 digit serial num-ber in the space provided in the back of this owner’s manual.Retain this operation and installation manual for future refer-ence and warranty.5. Remove the six (6) bolts on the back stove panel with an ad-justable wrench or a 10 mm socket. Discard the back paneland retain the bolts and washers to attach the rear cover pro-vided with the burner system.Figure 6 - Removing Back PanelBoltProductIdentificationLabelBack StovePanelCAST IRON STOVE ANDDIRECT-VENT BURNERSYSTEM ASSEMBLYPRE-INSTALLATION PREPARATIONLocation and Space Requirements (Cont.)CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLYStove Body Assembly27"