Desa "TUDOR" VT32N-A Series Owner's Operation And Installation Manual

Also see for "TUDOR" CGDV32NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com 116646-01A22LockUnlockGlass FrameAssemblyScrewFigure 42 - Removing/Replacing Glass DoorHingeRemoving Glass DoorIf replacement of glass is necessary, the entire assembly, glass andframe, must be replaced. If glass is broken, wear gloves and tapethe remaining fragments onto the frame.1. Remove screen assembly by pushing the rod either left or rightand then down and forward to remove screen/rod assemblyfrom the firebox. Set assembly aside.2. Lift up on latches to unlock. There are two on top of firebox andtwo below firebox that hold glass door in place (see Figure 42).3. While holding glass door to prevent it from falling and causinginjury, remove the five screws from the hinge located on theleft side of door frame assembly (see Figure 42).4. Remount the new frame at the hinge with five new screwsbefore closing door. This will ensure seating of the gasket.5. Close glass door frame. Lock latches by placing the bar under thetab on door and pushing down and back on latch (see Figure 42).6. Replace screen/rod assembly by reversing step 1.7. Replace louvers by reversing procedure under RemovingLouver Panels, page 21.LatchFIREPLACE INSTALLATIONContinuedFIREPLACE INSTALLATIONRemoving/Replacing Glass Door (Cont.)Installing Optional Brick Liner Model BL32DCleaning Glass DoorSee Cleaning and Maintenance on page 28.INSTALLING OPTIONAL BRICK LINERMODEL BL32DWARNING: If fireplace has been running, turnoff and unplug fireplace. Let cool before installingbrick liner.This brick liner kit is optional. You may purchase brick liner fromyour local retailer or see page 37.CAUTION: Always handle brick panels with twohands. Do not force brick panels into place. Exces-sive force will break brick panels.1. Remove top and bottom louvers to allow access to door latches.2. Unlock door latches and open glass door. See steps 1 and 2 ofRemoving/Replacing Glass Door, column 1.3. If installing brick liner in new fireplace, go to step 4. If install-ing brick liner in an existing fireplace, carefully remove logs,lava rock and ember material.4. Remove three screws from deflector shield on the inside topof firebox. Set shield and screws aside.5. Install rear brick panel first. Rest bottom edge of panel on backedge of grate (see Figure 43).6. Install left side brick panel by sliding it between the grate andthe side of the firebox (see Figure 44, page 23).7. Install the right brick panel using the same method described8. Replace deflector shield using screws removed in step 4.9. Follow instructions on page 23 to install logs, lava rock andember material.10. Close glass door, lock latches on top and bottom of door andreplace screen (see steps 5 and 6 of Removing Glass Door,column 1).11. Close top and bottom louvers.Figure 43 - Installing Rear Brick PanelRear Brick Panel