Desa UNVENTED (VENT-FREE) PROPANE GAS LOG HEATER Owner's Operation And Installation Manual

Desa UNVENTED (VENT-FREE) PROPANE GAS LOG HEATER Owner's Operation And Installation Manual Manual pdf 13 page image

13101309INSTALLINGContinuedINSTALLING DAMPER CLAMP ACCESSORY FORVENTED OPERATIONNote: When used as a vented heater, appliance must be installed only in a solid-fuel burning fireplace with a working flue and constructed of non combustiblematerial.If your heater is a manually controlled model, you may use this heater as a ventedproduct. There are three reasons for operating your heater in the vented mode.1. The fireplace does not meet the clearance to combustibles requirements forvent-free operation.2. State or local codes do not permit vent-free operation.3. You prefer vented operation.If reasons number 1 or 2 above apply to you, you must permanently open chimney fluedamper. You must install the damper clamp accessory (to order, see Accessories, page33). This will insure vented operation (see Figure 10). The damper clamp will keepdamper open. Installation instructions are included with clamp accessory.See chart below for minimum permanent flue opening you must provide. Attachdamper clamp so the minimum permanent flue opening will be maintained at all times.Area of Various Standard Round FluesDiameter (ins.) Area (sq. ins.)5" 20 sq. inches6" 29 sq. inches7" 39 sq. inches8" 51 sq. inchesChimney Minimum PermanentHeight (ft.) Flue Opening (sq. ins.)6' to 15' 39 sq. inches15' to 30' 29 sq. inchesDamperDamperClampDamperClampDamperDamperManufactured FireplaceMasonry FireplaceFigure 10 - Attaching Damper Clamp