Desa (V)B36 Owner's Operation And Installation Manual

Also see for (V)B36: OWNER'S OPERATION AND INSTALLATION MANUAL Installation instructions Installation instructions

Contents

www.fmiproducts.com 109034-01M6FIREPLACE INSTALLATIONContinuedFigure 4 - Mantel Clearances toCombustible MaterialElectricalBushingElectricalCoverPlateRockerSwitchFigure 6 - Fan Switch-Electrical BushingElectricalHousingWire Nut (3x)(Not Supplied)Outer Wrapperof FireplaceElectrical CoverPlate andElectrical BushingFireplace ChassisGroundTo PowerSourceReceptacle(Supplied)Power Source Wiring(Not Supplied)Prewired Receptacleand GroundMANTELSA mantel may be installed if desired (seeFigure 4). Woodwork such as wood trims,mantels or any other combustible materialprojecting from front face must not be placedwithin 9" of fireplace opening (and within 9"of top louver opening). Combustible materi-als above 9" and projecting more than 1 1/2"from fireplace must not be placed less than12" from top opening of fireplace (NFPA STD211, Sec. 7-3.3.3).Mantels or any other combustible materialmay come up to side edge of black metal faceof fireplace if projection from front face fallswithin limits shown in Figure 5.12 1 /4 " Ref.1 1 /2 "Max.Upper Sectionof CirculatingFireplace6"Ref.6"Min.33°3" Nom. *Note: DrawingNot To ScaleSafe Zone ForProjection ofCombustibleMaterialsCombustibleMaterial12"Min.9"Min.Fireplace OpeningTop ofLouveredOpeningFAN/BLOWER KIT ASSEMBLYFan or blower kit is optional with this fireplace(for circulating models only). Use of blowersor fans other than those manufactured byFMI PRODUCTS, LLC voids warranty. Fanis operated by pressing rocker switch (seeFigure 6) in lower right hand corner of fireplaceface. Blower is operated by turning controlknob (not shown).Fan/blower kit electrical connections aremade through electrical cover plate on sideof fireplace a shown in Figure 6.FIREBOXSAFE ZONEFigure 5 - Side Mantel ClearanceTop View of FireplaceMin. 12" fromPerpendicular Side Wall1"0.625" Max.33°9"Wiring Instructions1. Remove electrical cover plate with bush-ing from fireplace by removing 2 sheetmetal screws as shown in Figure 6.2. Slide power source wiring through electri-cal bushing opening and electrical coverplate and make all necessary connec-tions.3. Slide all wiring connections in electricalhousing as shown in Figure 6.4. Secure electrical cover plate with screwspreviously removed.Note: Electrical housing and cover plate havesharp edges. Wear protective gloves.SheetMetalScrews