Desa (V)K42P SERIES Owner's Operation And Installation Manual

Also see for K42N SERIES: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

111921-01DFor more information, visit www.desatech.comFor more information, visit www.desatech.com22Figure 43 - Installing Rear, Left and Right Side Brick PanelsRear BrickPanelLeft SideBrick PanelFIREPLACE INSTALLATIONContinuedFIREPLACE INSTALLATIONRemoving/Replacing Glass Door (Cont.)Installing Optional Brick Liner Models BL42DA(SA) and BL42DHA(SA)INSTALLING BRICK LINER MODELSBL42DA(SA) AND BL42DHA(SA)WARNING: If fireplace has been running, turnoff unit. Let cool before installing brick liner.You may purchase brick liner from your local retailer or seeAccessories, page 36.CAUTION: Always handle brick panels with twohands. Do not force brick panels into place. Exces-sive force will break brick panels.1. Remove top and bottom louvers to allow access to door latches.2. Unlock door latches and open glass door. See Removing/Re-placing Glass Door, steps 1 and 2.3. If installing brick liner in new fireplace, go to step 4. If install-ing brick liner in an existing fireplace, carefully remove logs,lava rock, and ember material.4. Remove three screws from deflector shield on the inside topof firebox. Set shield and screws aside.5. Install rear brick panel first. Rest bottom edge of panel on backedge of burner assembly (see Figure 43).6. Install left side brick panel by sliding it between the burnerassembly and side of firebox (see Figure 43).7. Install the right brick panel using the same method describedin step 6.8. Replace deflector shield using screws removed in step 4.9. Follow instructions to install logs, lava rock, and ember material.10. Close glass door and lock latches on top and bottom of door andreplace screen. See Removing/Replacing Glass Door, steps 5 and 6.11. Close top and bottom louvers.LockUnlockGlass FrameAssemblyScrewFigure 42 - Removing/Replacing Glass DoorHingeLatchRemoving Glass DoorsIf replacement of glass is necessary, the entire assembly, glass andframe, must be replaced. If glass is broken, wear gloves and tape theremaining fragments onto the frame.1. Remove screen assembly by pushing the rod either left or rightand then down and forward to remove screen/rod assemblyfrom the firebox. Set assembly aside.2. Lift up on latches to unlock. There are two on top of firebox andtwo below firebox that hold glass door in place (see Figure 42).3. While holding glass door to prevent it from falling and caus-ing injury, remove the five screws from the hinge located onthe left side of door frame assembly (see Figure 42).4. Remount the new frame at the hinge with five new screwsbefore closing door. This will ensure seating of the gasket.5. Close glass door frame. Lock latches by placing the bar under thetab on door and pushing down and back on latch (see Figure 42).6. Replace screen/rod assembly by reversing step 1.7. Replace louvers by reversing procedure under RemovingLouver Panels, column 1.Cleaning Glass DoorSee Cleaning and Maintenance on page 29.