Desa (V)V42PA(1) Owner's Operation And Installation Manual

Also see for (V)V42NA(1): OWNER'S OPERATION AND INSTALLATION MANUAL

111906-01BFor more information, visit www.desatech.comFor more information, visit www.desatech.com335. This fireplace reaches high temperatures. Keep children andadults away from hot surfaces to avoid burns or clothing igni-tion. Fireplace will remain hot for a time after shutdown. Al-low surfaces to cool before touching.6. Carefully supervise young children when they are in the roomwith fireplace.7. Do not modify this fireplace under any circumstances. Anyparts removed for servicing must be replaced prior to operat-ing fireplace.8. Turn fireplace off and let cool before servicing, installing, orrepairing. Only a qualified service person should install, ser-vice, or repair this fireplace. Have fireplace inspected annu-ally by a qualified service person.9. You must keep control compartments, burners, and circulat-ing air passages clean. More frequent cleaning may be neededdue to excessive lint and dust from carpeting, bedding mate-rial, etc. Turn off the gas valve and pilot light before cleaningfireplace.10. Have venting system inspected annually by a qualified serviceperson. If needed, have venting system cleaned or repaired.See Cleaning and Maintenance, page 29.11. Keep the area around your fireplace clear of combustible ma-terials, gasoline, and other flammable vapor and liquids. Donot run fireplace where these are used or stored. Do not placeitems such as clothing or decorations on or around fireplace.12. Do not use this fireplace to cook food or burn paper or otherobjects.13. Do not use any solid fuels (wood, coal, paper, cardboard, etc.)in this fireplace. Use only the gas type indicated on fireplacenameplate.14. This appliance, when installed, must be electrically groundedin accordance with local codes or, in the absence of local codes,with the National Electrical Code, ANSI/NFPA 70, or the Ca-nadian Electrical Code, CSA C22.1.15. Do not use fireplace if any part has been exposed to or underwater. Immediately call a qualified service person to arrangefor replacement of the unit.16. Do not operate fireplace if any log is broken.17. Do not use a blower insert, heat exchanger insert, or other ac-cessory not approved for use with this fireplace.18. Do not operate fireplace with glass door removed, cracked, orbroken.19. Provide adequate clearances around air openings.SAFETY INFORMATIONContinuedPRODUCT IDENTIFICATIONFigure 1 - Direct-Vent Fireplace with Millivolt IgnitionLOCAL CODESInstall and use fireplace with care. Follow all local codes. In theabsence to local codes, use the current National Fuel Gas CodeANSI Z223.1/NFPA 54* (USA) or the current CSA-B149.1 Instal-lation Code (Canada).*Available from:American National Standards Institute, Inc.1430 BroadwayNew York, NY 10018National Fire Protection Association, Inc.Batterymarch ParkQuincy, MA 02269SAFETY INFORMATIONPRODUCT IDENTIFICATIONLOCAL CODESGlassDoorAssemblyBlower Switch(BKT Standard withCHDV Models)PiezoIgnitorControlValveLogSetGrateAssemblyLavaRockGlowingEmbersUpper LouverPanelLowerLouverPanelFlue CollarNailingFlangeON/OFF/REMOTE Switch(Optional Installation)