Desa VDCFTNB Owner's Operation And Installation Manual

Also see for CDCFNRA: OWNER'S OPERATION AND INSTALLATION MANUAL Operation and installation manual

Contents

www.desatech.com123502-01C 19iNsTallaTioNContinuedopERaTioNTHERmosTaT-CoNTRollED moDElshand, don’t try to repair it, call a quali-fied service technician or gas supplier.Force or attempted repair may result ina fire or explosion.D. Do not use this appliance if any parthas been under water. Immediately calla qualified service technician to inspectthe appliance and to replace any part ofthe control system and any gas controlwhich has been under water.LIGHTINGINSTRUCTIONSWARNING: You must operatethis fireplace with the screenin place. Make sure fireplacescreen is installed before run-ning fireplace.NOTICE: During initial operationof new fireplace, burning logswill give off a paper-burningsmell. Open window to ventsmell. Operate fireplace on HIposition to burn off odor. Thiswill only last a few hours.1. STOP! Read the safety information start-ing in column 1.FOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which mustbe lighted by hand. When lightingthe pilot, follow these instructionsexactly.b. bEFORE LIGHTING smell all aroundthe appliance area for gas. be sure tosmell next to the floor because somegas is heavier than air and will settleon the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; donot use any phone in your building.• Immediately call your gas supplierfrom a neighbor’s phone. Follow thegas supplier’s instructions.• If you cannot reach your gas supplier,call the fire department.C. Use only your hand to push in or turnthe gas control knob. Never use tools.If the knob will not push in or turn byFigure 31 - Installing ScreenScreenScreenRodRingsScreen AssemblyFront CenterHole forRight ScreenAssemblyBack Center Hole forLeft Screen Assembly5. Insert each rod through ten rings locatedat top of screen (see Figure 31).6. Insert first rod into hole in left side of fire-box. Fasten rod to rear hole near centerof firebox using black Phillips head screw(see Figure 31).7. Insert other rod into hole on right side offirebox and fasten rod to front hole nearcenter of firebox using remaining sheetmetal screw.