www.desatech.com111035-01F 5UNPACkINGCAUTION: Do not remove thedata plates from the grate as-sembly. The data plates containimportant warranty and safetyinformation.1. Remove logs and heater base assembly fromcarton. Note: Do not pick up heater base as-sembly by burners. This could damage heater.Always handle base assembly by grate.2. Remove all protective packaging applied tologs and heater for shipment.3. Check all items for any shipping damage. Ifdamaged, promptly inform dealer where youbought heater.OPTIONAL REMOTECONTROL ACCESSORIESThere are four optional remote controls thatcan be purchased separately for Remote-ReadyModels Only:• wall switch • hand-held ON/OFF remote• wall thermostat • hand-held thermostat remoteSee Accessories, page 39.The wall thermostat or hand-held thermostatmay not be used where vented decorative listingis required.PRODUCT FEATURESOPERATIONThis heater is clean burning. It requires no outsideventing. There is no heat loss out a vent or up achimney. Heat is generated by realistic flames. Thisheater is designed for vent-free operation with fluedamper closed. It has been tested and approvedto ANSI Z21.11.2 standard for unvented heaters.State and local codes in some areas prohibit theuse of vent-free heaters. This heater may also beoperated as a vented decorative (ANSI Z21.60)product by opening the flue damper.SAFETY DEvICEThis heater has a pilot with an Oxygen Deple-tion Sensing (ODS) safety shutoff system. TheODS/pilot is a required feature for vent-free roomheaters. The ODS/pilot shuts off the heater if thereis not enough fresh air.PIEZO IGNITION SYSTEMThis heater has a piezo ignitor. This system re-quires no matches, batteries or other sources tolight heater.OFFPILOTONHILOOFFPILOTONHILOPRODUCTIDENTIFICATIONFigure 1 - Product IdentificationFlame-Max® American Chestnut Logswith Remote ControlFlame-Max® Classic Walnut Logs withManual ControlPiezoIgnitorControlKnobControl Cover LogControl Cover LogOptionalRemoteControlControlKnobFlameAdjustmentKnobPiezoIgnitor