108661-01DFor more information, visit www.desatech.comFor more information, visit www.desatech.com24FIREPLACE INSTALLATIONInstalling Logs, Lava Rock and Glowing Embers (Cont.)FIREPLACE INSTALLATIONContinued3. Place log #3 (crossover log) onto the rear and front logs. Makesure it is seated properly on the smooth surface on the front logand on the pin on the back log as shown in Figure 47.4. Place log #4 (right log) on the pin on the right side of front logas shown in Figure 48.5. Place log #5 (base log) onto the front left part of the grate makingsure the notches fit over the prongs of the grate). See Figure 49.6. Place log #6 (left log) onto two pins on the left side of back andfront log. See Figure 49.7. Place lava rock along sides and front of firebox bottom in ar-eas that are visible only. It is not necessary to use all of thelava rock provided.WARNING: The glass door must be securely inplace before running this fireplace. Do not run thisfireplace if glass is missing or broken.NOTICE: Do not put lava rock on burner or underburner. Placing lava rock on burner will cause perfor-mance problems.4Ember MaterialFigure 50 - Placing Ember Material on BurnerFigure 48 - Installing Log No. 456Figure 49 - Installing Logs No. 5 and No. 63Figure 47 - Installing Log No. 38. Pull ember material apart into pieces no larger than a dime.Place these pieces loosely and sparingly directly onto the ex-posed section of the front burner and along the space betweenthe burner and grate prongs (see Figure 50). This will createthe glowing ember appearance as the flame touches the embermaterial. Do not block air slots by using too much ember ma-terial in one area. It is not necessary to use all of the embermaterial provided.9. Close glass door, lock door latches, replace screen and closelouvers (see steps 5 and 7 of Removing/Replacing Glass Door,page 22).