Desa VV36EPC1 Series Owner's Operation And Installation Manual

Also see for V36EN-B SERIES: OWNER'S OPERATION AND INSTALLATION MANUAL

111253-01EFor more information, visit www.desatech.comFor more information, visit www.desatech.com2121FIREPLACE INSTALLATIONContinuedFIREPLACE INSTALLATIONRemoving/Replacing Glass DoorREMOVING/REPLACING GLASS DOORCAUTION: Do not operate this fireplace with abroken glass door panel or without the glass doorpanel securely in place. For replacement part infor-mation seeReplacement Parts, page 34.Removing Louver PanelsRemove the top and bottom louver panels by simultaneously pullingboth top end spring latches towards the center of the appliance untilthey are disengaged from the locating holes (see Figure 36). Repeatfor bottom spring latches and pull the louvers outward. To install orreplace items removed, simply reverse the procedures above.Figure 36 - Removing Louver PanelLouver PanelCAUTION: Wear gloves and safety glasses whilehandling or removing broken glass. Do not remove ifglass is hot. Keep children and pets away from glass.WARNING: If fireplace has been running, turnoff and unplug fireplace. Let cool before removingglass door or louvers.Spring LatchRemoving Glass DoorIf replacement of glass is necessary, the entire assembly, glass andframe, must be replaced. If glass is broken, wear gloves and tape theremaining fragments onto the frame.1. Remove screen assembly by pushing the rod either left or rightand then down and forward to remove screen/rod assemblyfrom the firebox. Set assembly aside.2. Lift up on latches to unlock. There are two on top of firebox andtwo below firebox that hold glass door in place (see Figure 37).3. While holding glass door to prevent it from falling and caus-ing injury, remove the five screws from the hinge located onthe left side of door frame assembly (see Figure 37).4. Remount the new frame at the hinge with five new screwsbefore closing door. This will ensure seating of the gasket.5. Close glass door frame. Lock latches by placing the bar under thetab on door and pushing down and back on latch (see Figure 37).6. Replace screen/rod assembly by reversing step 1.7. Replace louvers by reversing procedure under Removing Lou-ver Panels.LockUnlockGlassFrameAssemblyScrewFigure 37 - Removing/Replacing Glass DoorHingeLatchCleaning Glass DoorSee Cleaning and Maintenance on page 27.