Desa VV42ENA1 Series Owner's Operation And Installation Manual

Also see for Victorian V42EN-A Series: OWNER'S OPERATION AND INSTALLATION MANUAL

111907-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com2525OPERATING FIREPLACEOPERATING FIREPLACEFor Your Safety Read Before LightingLighting InstructionsTo Turn Off Gas To ApplianceOptional Remote OperationFigure 49 - Turning Equipment Shutoff Valve to the OFF PositionTO TURN OFF GASTO APPLIANCE1. Turn off the wall switch.2. Turn off all electric power to the appliance if service is tobe performed.3. Open lower louver panel.4. Remove front hearth brick and control access panel.5. Turn equipment shutoff valve clockwise Clockwise to OFF.Do not force.6. Close lower louver panel.Figure 50 - PilotSensing RodPilot BurnerIgnitorLIGHTINGINSTRUCTIONS1. STOP! Read the safety information, above.2. Turn off all electric power to the appliance.3. Turn wall switch to the OFF position.4. Open lower louver panel.5. Turn equipment shutoff valve clockwise Clockwise to the OFFposition (see Figure 49). Do not force.6. Wait five (5) minutes to clear out any gas. Then smell forgas, including near the floor. If you smell gas, STOP! Fol-low “B” in the safety information above. If you don’t smellgas, go to the next step.7. Turn equipment shutoff valve counterclockwise C-clockwiseto the ON position. Do not force.8. Close lower louver panel.9. Turn on all electric power to the appliance.10. Turn the wall switch to the ON position.NOTICE: During initial operation of new heater, burn-ing logs will give off a paper-burning smell. Orangeflame will also be present. Open damper or window tovent smell. This will only last a few hours.11. Visually locate the pilot. The ignitor should begin to spark andthe main burner should ignite once flame appears at pilot.• If lighting the appliance for the first time each season, itmay take several attempts before the supply gas can reachthe pilot and main burners.• If the appliance will not stay lit after several attempts,follow the instructions To Turn Off Gas To Appliance,below, and call your service technician or gas supplier.FOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not follow these instructionsexactly, a fire or explosion may result causing prop-erty damage, personal injury or loss of life.A. This appliance is equipped with an ignition device whichautomatically lights the pilot. Do not try to light the pilotby hand.B. BEFORE LIGHTING smell all around the appliance areafor gas. Be sure to smell next to the floor because some gasis heavier than air and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch.• Do not use any phone in your building.• Immediately call your gas supplier from a neighbor’sphone. Follow the gas supplier’s instructions.• If you cannot reach your gas supplier, call the firedepartment.C. Do not use this appliance if any part has been under water.Immediately call a qualified service technician to inspectthe appliance and to replace any part of the control systemand any gas control which has been under water.Equipment Shutoff ValveOPTIONAL REMOTEOPERATIONNote: The WRC receiver and hand-held remote control kitmust be purchased separately (see Accessories, page 37). Followinstallation instructions on page 24.1. Turn equipment shutoff valve to ON position. You can now turnthe burner on and off with the hand-held remote control unit.IMPORTANT: Be sure to press the ON/OFF buttons on thehand-held remote control unit for up to 3 seconds to assureproper operation.2. Press the ON/OFF button to turn the burner on and off.AdjustmentScrew