Desa Vanguard VI33NRA Owner's Operation And Installation Manual

Contents

Desa Vanguard VI33NRA Owner's Operation And Installation Manual Manual pdf 15 page image

110150-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com1515INSTALLATIONContinuedINSTALLATIONInstalling 9-Volt BatteriesOPERATING FIREPLACE INSERTFor Your Safety Read Before LightingLighting InstructionsFigure 30 - Installing Battery in Remote ReceiverINSTALLING 9-VOLT BATTERIESTwo 9-volt batteries (not included) are required to operate thisheater with the wireless hand-held remote control set. Install onebattery in the receiver and one in the hand-held remote control unit.Note: Only use alkaline batteries.Installing 9-Volt Battery (Not Included) in Receiver1. Locate back of receiver under front burner of heater.2. Locate the battery clip mounted on the back of the receiver.3. Slide a 9-volt battery through the clip.4. Attach the terminal wires to the battery.Battery Clip9-Volt BatteryTerminalWiresRemoteReceiverInstalling 9-Volt Battery (Not Included) in Hand-Held Remote Control Unit1. Remove battery cover on back of remote control unit.2. Attach terminal wires to the battery. Place battery into the bat-tery housing.3. Replace battery cover onto remote control unit. ModelGHRCTAFigure 31 - Installing Battery in Hand-Held Remote Control UnitBatteryCoverTerminalWires RemoteControl Unit9-VoltBattery BatteryHousingModelGHRCOPERATING FIREPLACEINSERTFOR YOUR SAFETY READBEFORE LIGHTINGWARNING: If you do not follow these instructionsexactly, a fire or explosion may result causing prop-erty damage, personal injury or loss of life.A. This appliance has a pilot which must be lighted by hand.When lighting the pilot, follow these instructions exactly.B. BEFORE LIGHTING smell all around the appliance areafor gas. Be sure to smell next to the floor because some gasis heavier than air and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do not use any phone inyour building.• Immediately call your gas supplier from a neighbor’sphone. Follow the gas supplier’s instructions.• If you cannot reach your gas supplier, call the fire de-partment.C. Use only your hand to push in or turn the gas control knob.Never use tools. If the knob will not push in or turn byhand, don’t try to repair it, call a qualified service techni-cian or gas supplier. Force or attempted repair may resultin a fire or explosion.D. Do not use this appliance if any part has been under water.Immediately call a qualified service technician to inspectthe appliance and to replace any part of the control systemand any gas control which has been under water.LIGHTING INSTRUCTIONSWARNING: You must operate this heater with thefireplace insert screen in place. Make sure fireplaceinsert screen is installed before running fireplace insert.NOTICE: During initial operation of new fireplaceinsert, burning logs will give off a paper-burningsmell. Open damper or window to vent smell. This willonly last a few hours.1. STOP! Read the safety information above.2. Make sure equipment shutoff valve is fully open.3. Set switch to OFF position.WARNING: Burners will come on automaticallywithin one minute when the remote selector switch isin the ON position after the pilot is lit.