Desa Vanguard VP1600C Owner's Operation And Installation Manual

Contents

12100751Marking Screw Locations1. Tape mounting bracket to wall where heater will be located. Make sure mount-ing bracket is level.2. Mark screw locations on wall (see Figure 8).Note: Only mark last hole on each end of mounting bracket. Insert mountingscrews through these holes only.3. Remove tape and mounting bracket from wall.Models VP2600C and VP2200IT Models VP1600C and VP1600IT18 3/4"Min.13"Min.16"18 3/4"Min.9 1/4"Min.Adjoining Wall16"Adjoining WallOnly Insert MountingScrews Through LastHole On Each EndOnly Insert MountingScrews Through LastHole On Each EndFloor FloorFigure 8 - Mounting Bracket ClearancesAttaching Mounting Bracket To WallNote: Wall anchors, mounting screws, and spacers are in hardware package. Thehardware package is provided with heater.Attaching to wall stud methodFor attaching mounting bracket to wall studs1. Drill holes at marked locations using 9/64" drill bit.2. Place mounting bracket onto wall. Line up last hole on each end of bracket withholes drilled in wall.3. Insert mounting screws through bracket and into wall studs.4. Tighten screws until mounting bracket is firmly fastened to wall studs.Attaching to wall anchor methodFor attaching mounting bracket to hollow walls (wall areas between studs) or solidwalls (concrete or masonry)1. Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete ormasonry), drill at least 1" deep.2. Fold wall anchor as shown in Figure 9.3. Insert wall anchor (wings first) into hole. Tap anchor flush to wall.INSTALLINGTO WALLContinued WARNING ICON G 001WARNINGMaintain minimum clearances shown in Figure 8. If you can,provide greater clearances from floor and joining wall.Figure 9 - Folding Anchor