Design Dynamics VF-18N-BTB Owner's Operation And Installation Manual

Also see for VF-18N-BTB: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Design Dynamics VF-18N-BTB Owner's Operation And Installation Manual Manual pdf 3 page image

111826-01For more information, visit www.desatech.com33SAFETY INFORMATIONContinuedPRODUCT IDENTIFICATIONFigure 1 - Product Identification1. This appliance is only for use with the type of gas indicated onthe rating plate. This appliance is not convertible for use withother gases.2. Do not place propane/LP supply tank(s) inside any structure.Locate propane/LP supply tank(s) outdoors (propane/LP unitsonly).3. If you smell gas• shut off gas supply• do not try to light any appliance• do not touch any elec tri cal switch; do not use any phone inyour build ing• immediately call your gas supplier from a neighbor’s phone.Follow the gas supplier’s instructions• if you cannot reach your gas supplier, call the fire depart-ment4. This heater shall not be installed in a bedroom or bathroom,unless installed as a vented appliance. See Installing DamperClamp Accessory for Vented Op era tion, page 10.5. Before installing in a solid fuel burn ing fireplace, the chim-ney fl ue and fi re box must be cleaned of soot, creosote, ashesand loose paint by a qualified chimney cleaner. Creosote willignite if highly heated. Inspect chimney flue for damage.If damaged, repair flue damper before operating heater.6. If fireplace has glass doors, never operate this heater withglass doors closed. If you operate heater with doors closed,heat buildup inside fi replace will cause glass to burst. Also iffire place open ing has vents at the bottom, you must open thevents before oper at ing heater.7. To prevent the creation of soot, follow the instructions in Clean-ing and Main te nance, page 18.8. Before using furniture polish, wax, carpet cleaner, or similarproducts, turn heater off. If heated, the vapors from these prod-ucts may create a white pow der residue within burner box oron adjacent walls and furniture.9. This heater needs fresh, outside air ven ti la tion to run properly.This heater has an Oxygen Depletion Sensing (ODS) safetyshutoff system. The ODS shuts down the heater if enough freshair is not available. See Air for Combus tion and Ven ti la tion,pages 4 through 6. If heater keeps shut ting off, see Trou ble -shoot ing, pages 19 through 21.10. Do not run heater• where flammable liquids or vapors are used or stored• under dusty conditions11. Do not use this heater to cook food or burn paper or other ob-jects.12. Do not use heater if any part has been exposed to or under water.Im me di ate ly call a qualified service technician to in spect theroom heater and to replace any part of the control sys tem andany gas control which has been under wa ter.13. Do not operate heater if any log is broken. Do not operate heaterif a log is chipped (dime-sized or larger).14. Turn heater off and let cool before servicing, installing, orre pair ing. Make sure the selector switch is in the OFF position(Remote-Ready Models Only). Only a qualified service personshould install, service, or repair heater.15. Make sure the selec tor switch is in the OFF posi tion when youare away from home for long periods of time (Remote-ReadyMod els Only).16. Remote-Ready heaters do not to be connected to any ex ter nalelec tri cal source.17. Operating heater above elevations of 4,500 feet may cause pilotoutage.18. To prevent performance problems, do not use propane/LP fueltank of less than 100 lb. capacity (propane/LP units only).19. Provide adequate clearances around air openings.SAFETY INFORMATIONPRODUCT IDENTIFICATIONLog SetPiezoIgnitorControl KnobsChassis AssemblyLog SetPiezoIgnitorRemoteControlControl KnobsRemoteRecieverChassis AssemblyREMOTE READY MODELSREMOTE CONTROLLED MODELSLava RockLog ScrapsLava RockLog Scraps