Duralloy ARC 161 PFC Owner's Manual

Contents

Duralloy ARC 161 PFC Owner's Manual Manual pdf 8 page image

Keep your welding machine in top conditionThe DURALLOY ARC 161/201 PFC does not require any specialmaintenance, however the user should take care of the machineas follows:• Regularly clean the ventilation slots.• Keep the casing clean.• Check all cables before use.• Check electrode holders, work lead/clamps and weldingtorches before use.• Replace worn electrode holders and earth clamps, which donot provide a good connection.• Replace worn consumable parts in a timely manner.• Use a soft cloth or brush to clean electrical components.• Do not use liquid cleaning products, water or especiallysolvents.• Do not use compressed air to clean electrical components asthis can force dirt and dust further into components, causingelectrical short circuits.• Check for damaged parts. Do not use the welderwithdamaged parts.• A damaged welder must be carefully checked by a qualifiedperson to determine that it will operate properly. Check forbreakage of parts, mountings and other conditions that mayaffect its operation. An authorised service centre shouldproperly repair a damaged part. Have your welder repairedby an expert.This appliance is manufactured in accordance with relevant safetystandards. Only experts must carry out repairing of electricalappliances, otherwise considerable danger for the user mayresult. Use only genuine replacement parts. Do not use modifiedor non-genuine parts.Storing the WelderWhen not in use the welder should be stored in the dry and frost-free environment.WARNING!Before performing cleaning/maintenance, replacingcables / connections , make sure the welding machine isswitched off and disconnected from the power supply.www.duralloy.net.au | 1300 369 456CARE & MAINTENANCESize of ElectrodesThe electrode size is determined by the thickness of metalsbeing joined and can also be governed by the type of weldingmachine available. Small welding machines will only providecurrent (amperage) to run smaller sized electrodes.For thin sections, it is necessary to use smaller electrodesotherwise the arc may burn holes through the job. A little practicewill soon establish the most suitable electrode for a givenapplication.Storage of ElectrodesAlways store electrodes in a dry place and in their originalcontainers.Electrode PolarityElectrodes are generally connected to the electrode holder withthe electrode holder connected positive polarity.The work lead is connected to the negative polarity and isconnected to the work piece. If in doubt consult the electrodedata sheet.ELECTRODES8ARC 161/201 PFCOWNER’S MANUAL