1 Operation Manual - Dux Endurance Continuous Flow Hot Water®Your Dux Endurance Continuous Flow Water Heater has been certified by the Australian GasAssociation.The A.G.A. Certification Number is shown on the data plate.This Appliance must be installed correctly by an authorised person. The installation of gas, water, andelectricity must conform to local regulations.The installation must also comply with the instructions supplied by Dux.All dimensions referred to in these instructions are in millimetres, unless otherwise specified.Please keep this instruction booklet in a safe place for future reference.Notice to Victorian ConsumersThis appliance must be installed by a person licensed with the Plumbing Industry Commission.Only a licensed person will have insurance protecting their workmanship.So make sure you use a licensed person to install this appliance and ask for your ComplianceCertificate. For Further information contact the Plumbing Industry Commission on 1800 015 129.Heated water can be dangerous, especially for youngchildren and the infirm.Water temperatures above 50°C can cause severe burnsinstantly and may even result in death.Those most at risk are children, disabled, elderly and theinfirm.Hot water at 65°C (a very common hot water temperature inAustralia) can severely burn a child in less than half a second.At 50°C it takes five minutes.ALWAYS......Test the temperature of the water with your elbow before placing your child in the bath, alsocarefully feel water before bathing or showering yourself.Supervise children whenever they are in the bathroom.Make sure that the hot water tap is turned off tightly.CONSIDER.....Installing child proof tap covers or child resistant taps (both approaches will prevent a smallhand being able to turn on the tap).Setting your appliance at a maximum temperature of 50°C (Contact Dux).NEVER…..Leave a toddler in the care of another child. They may not understand the need to have thewater temperature set at a safe level.REGULATORY INFORMATIONWARNING ABOUT HOT WATER