15”/19“/22” LCD TVQUICK SETUP GUIDEDX-15L150A11/DX-19L150A11 /DX-22L150A11HDMI cable(not included)HDMI deviceAUDIO INComponent video deviceComponentvideo cableVideo device S-video cableRemotecontrol and 2AAA batteriesComponentvideo cableAC powercordTV stand and 4 M4 screwsQuick Setup GuideL/R Audio cableANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INFront and side featuresInstalling the stand1 Remove the stand from the box and place it on a table or bench.2 Lay the TV on a flat, cushioned surface.3 Carefully align and insert the base into the stand until the lockingmechanism clicks into place.Installing a wall-mount bracket1 Carefully place your TV screen face-down on a cushioned, clean surface toprotect the screen from damages and scratches.2 Remove the three screws holding the TV to its stand column, then removethe stand column.3 Insert and lock the standoff screws (provided) into into the 4 holes on theback of the TV..4 Secure the wall-mount bracket to the back of your TV by screwing four M4screws provided with the bracket into the standoff screws you justinstalled.Setting up your remote control1 While pressing the release button on the battery compartment cover onthe back of the remote, lift the cover off the remote.2 Insert two AAA batteries into the battery compartment. Make sure that the+ and – symbols on the batteries align with the + and – symbols in thebattery compartment.3 Replace the cover.To program your existing universal remote control to work with your newDynex TV, see the table below for common codes. If you have problemsprogramming your remote or need a different remote control code, visitwww.dynexproducts.com for the latest remote control code information.Connecting a DVD or Blu-ray DVD player, cablebox, satellite receiver or game stationUsing HDMI (best)Connecting an antennaConnect a 75 ohm cable (not included) to RF jack on the back of your TV andthe RF OUT jack on the antenna.Connecting a home theater systemUsing analog audio cable:Note: Cable connectors and jacks are often color-coded.Match the colors when you connect the AV cable.Using digital audio cable:Note: The DIGITAL OUTPUT jack only works with digital TV channels.Remotecontrol sensorPowerindicatorUniversal remote control TV codes (for all Dynex TVs manufactured after Jan. 1, 2007)PhilipsPHDVD5, PH5DSS,PMDVR8, PDVR8115DirectTVRC2310463RCARCU807135One for AllURC-66900464SonyRM-VL6008043ComcastM10570463Dish NetworkVIP508, VIP622720MotorolaDRC8000463TIVOSeries 3, HD0091Universal remote control makers and models Set-top box makers and modelsUsing S-video (fair)Connecting a ComputerUsing component (better)Back of TVAudio CableAudio CableAUDIO INBack of TVBack of TVBack of TVBack of TVBack of TVBack of TVLocating grooves