Dynex DX-E101 Installation Manual

Also see for DX-E101: User guide Quick setup guide

Dynex DX-E101 Installation Manual Manual pdf 5 page image

Installing the adapter 53 Connect the other end of the cable to the WOL connector on the systemboard.4 Turn on your computer and press Delete or F1 when prompted to enter theBIOS Setup utility. The keys you press to enter the BIOS Setup utility mayvary. See your computer’s user guide. Enable the WOL function or power-onfunction of the computer. The name of this function is system dependent,but it may be located in a category heading titled such as “PowerManagement.” See your computer‘s user guide for more informationregarding the BIOS Setup utility and BIOS settings.Installing the driversWINDOWS XPTo install the adapter drivers in Windows XP:1 Make sure that you have installed the adapter into your computer and haveconnected the network cable.2 Turn on your computer. After Windows XP automatically installs the drivers,a Found New Hardware message appears next to the clock on the Windowstaskbar.3 If Windows does not automatically install the drivers, follow theinstructions in “Manually installing the drivers in Windows XP” on page 5.M ANUALLY INSTALLING THE DRIVERS IN WINDOWS XPTo manually install the drivers in Windows XP:1 Click Start, right-click My Computer, then click Properties. The SystemProperties box opens.Dynex5x7-multi.book Page 5 Wednesday, September 14, 2005 9:09 AM