Dynex DX-LCD19-09 User Manual

Also see for DX-LCD19-09: User guide

Contents

Setting up your TV 7Setting up your TVInstalling remote control batteriesTo install the remote control batteries:1 Remove the battery cover.2 Insert two AAA batteries into the battery compartment. Makesure that you match the + and – symbols on the batteries withthe + and – symbols in the battery compartment.3 Replace the cover.Notes:Do not mix batteries of different types.Do not mix old and new batteries.Remove batteries when the charge is depleted.Battery chemicals can cause a rash. If the batteries leak, clean the batterycompartment with a cloth. If chemicals touch your skin, washimmediately.If the remote control is not going to be used for an extended period of time,remove the batteries.Connecting your TV to a power outletTo connect your TV to a power outlet:• Plug the power cord into a power outlet.Notes:Make sure that you use the correct type of power. See the label on your TV.If you do not intend to use your TV for an extended period of time, unplugthe power cord from the power outlet.Connecting an outside antennaAntenna cables come in two types: 75 ohm and 300 ohm.• If your antenna cable has a 75 ohm connector, connect the cableto the coaxial jack on the back of your TV.• If your antenna cable has a 300 ohm connector, connect the cableto a 300-75 ohm adapter (not included), connect the adapter to a75 ohm cable, then connect the other end of the 75 ohmconnector to the coaxial jack on the back of your TV.Connecting cable TVYour TV has a 75 ohm jack for connecting cable TV.Some cable TV providers scramble the signals for “premium” (pay)channels. To view these channels, you need a converter/descramblerbox.If you do not have a converter/descrambler box, you can connect yourcable TV directly to your TV. If you have a converter/descrambler box,you can connect your cable TV using an RF switch (not supplied). Formore information about connecting a converter/descrambler box,contact your cable TV provider.To connect cable TV without a converter/descrambler box:1 Connect one end of a 75 ohm cable to the coaxial jack on the backof your TV.2 Connect the other end of the cable to the cable TV wall outlet.To connect cable TV with a converter/descrambler box:• Use the following illustration to connect a converter/descramblerbox. (The RF switch and the signal splitter are not provided.)Set the RF switch to the A position to tune to unscrambledchannels using your TV remote control. Set the RF switch to the Bposition to watch scrambled channels using theconverter/descrambler controls.75 ohm cable300 ohm cableRF switchCable converter/descrambler boxTwo-set signal splitterOut InABTV