1 Insert the swivel head into the swivelhead slot on the back of the holder andslide it into place until it is secure.2 Remove the thumbscrew on the bikemount and set it aside.3 Adjust the handlebar clamp to asize that best fits your bike frame orhandlebars, then insert and securelytighten the thumbscrew removedearlier.4 Loosen the adjustment or swivel headknobs to adjust the viewing angle, thenretighten.Package contents• Bike mount• Car mount• Holder• Quick Setup GuideCaution: Do not adjust your Dynex bikeand car mount while riding a bike ordriving a car.FeaturesYour Dynex bike and car mount securelyholds most MP3 players or smart phonesto your bike frame, handlebars, or carwindow. Make sure that your electronicdevice is securely fastened to the mountbefore you begin your trip.Caution: This mount is not intended forextreme off-road use. Excessive bumpingand jarring may result in damage to yourdevice.DX-MP3MTBicycle and car mount for MP3 devicesHolder (closed)Holder (open)Attaching an MP3 device tothe holder1 Repeatedly press the release buttonon the side of the holder. The clampsopen.2 Unfold the feet on the bottom of theholder.3 Adjust the clamps to fit the height ofyour device.4 Insert your device on the holder andclose the clamps by squeezing themtogether tightly until your device issecure.Attaching to a bikeBike mountClampsFeetReleasebuttonSwivelhead slotQUICK SETUP GUIDEHandlebarclamp360° swivelheadAdjustmentknobThumbscrewSwivel headknob