Dynex DX-R32TV User Manual

Contents

Dynex DX-R32TV User Manual Manual pdf 5 page image

Setting up the television 5Setting up the televisionConnecting your television to AC powerUse the AC polarized cord provided for operation on AC. Insert the ACplug into a standard 120V 60 Hz polarized AC outlet.Notes:Never connect the AC plug to other than the specified voltage (120V 60 Hz).Use the attached power cord only.If the polarized AC cord does not fit into a non-polarized AC outlet, do notfile or cut the blade. It is your responsibility to have an electricianreplace the obsolete outlet.If you cause a static discharge when touching the television and thetelevision fails to work, unplug the television from the AC outlet, thenplug it back in. The television should work normally.Installing batteries in the remote controlBefore using the remote control, you must install batteries. Use two AAAsize batteries. The batteries may last about one year depending on howmuch the remote control is used. For best performance, we recommendthe batteries should be replaced on a yearly basis, or when the remoteoperation becomes erratic. Do not mix old and new batteries or differenttypes.To install batteries in the remote control:1 Open the battery compartment cover.2 Install two AAA batteries.No. Button Description4 SLEEP To set the television to turn off aftera preset amount of time, press theSLEEP button. The clock counts upten minutes each time the button ispressed in the order of 0, 10,20...100, 110, 120 minutes. After thesleep time is programmed, thedisplay disappears then reappearsmomentarily every ten minutes toremind you the sleep timerfunction is operating. To confirmthe sleep time setting, press theSLEEP button once and theremaining time is momentarilydisplayed. To cancel sleep time,press the SLEEP button repeatedlyuntil the display turns to 0.5 VOL + / - Press the + button to increase thevolume level. Press the - button todecrease the volume level. Usethese buttons to select the desiredsetting during the menu screenoperation.6 MENU/ENTER Press to display the menu screenfunction.Press to enter or select operationsduring operation of the menuscreen.7 EXIT Press to remove the menu screen.8 INPUT Press this button to display theSOURCE SELECTION menu toselect the video input source.9 RECALL Press this button to go back to thepreviously viewed channel. Pressthis button again to return to thechannel you were watching.10 MUTE To turn off the sound, press thisbutton once. The television issilenced and the symbol MUTEappears on the screen. The mutingfeature can be turned off bypressing the MUTE button again orone of the VOL + or - buttons.11 CH + / - Press the CH + (up) button to changeto a higher numbered channel setinto memory. Press the CH - (down)button to change to a lowernumbered channel set intomemory. Use to select the desiredsetting during menu operation.12 ZOOM Press this button to change thepicture size.13 AUDIO Press this button to select thedesired sound.14 CCD Press this button to display theCLOSED CAPTION menu.15 TUNER Press this button to select theanalog/digital mode.AC outletWider hole andbladePolarized AC plug (one blade is widerthan the other.)