Dynex DX-WGDTC User Manual

Also see for DX-WGNBC: Manual

Contents

FCC 7FCCFederal Communication Commission InterferenceStatementThis equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouragedto try to correct the interference by one of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.FCC Caution: Any changes or modifications not expressly approved by theparty responsible for compliance could void the user's authority tooperate this equipment.This device complies with Part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) This device may not cause harmfulinterference, and (2) this device must accept any interference received,including interference that may cause undesired operation.Important Note (for DX-WGNBC)FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth foran uncontrolled environment. End users must follow the specificoperating instructions for satisfying RF exposure compliance. Thistransmitter must not be co-located or operating in conjunction with anyother antenna or transmitter. This equipment has been SAR-evaluatedfor use in laptops (notebooks) with side slot configuration.Important Note (for DX-WGDTC)FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth foran uncontrolled environment. This equipment should be installed andoperated with minimum distance 20cm between the radiator & yourbody. This transmitter must not be co-located or operating inconjunction with any other antenna or transmitter.Dynex declares that DX-WGNBC (FCC ID: MXF-P950529G) is limited inCH1~CH11 for 2.4 GHz by specified firmware controlled in U.S.A.Dynex declares that DX-WGDTC (FCC ID: MXF-P950605G) is limited inCH1~CH11 for 2.4 GHz by specified firmware controlled in U.S.A.IC statement (for DX-WGDTC)Operation is subject to the following two conditions: (1) This device maynot cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device.This device has been designed to operate with an antenna having amaximum gain of 5 dBi. Antenna having a higher gain is strictlyprohibited per regulations of Industry Canada. The required antennaimpedance is 50 ohms.Important NoteIC Radiation Exposure Statement:This equipment complies with IC radiation exposure limits set forth foran uncontrolled environment. This equipment should be installed andoperated with minimum distance 20cm between the radiator & yourbody. This transmitter must not be co-located or operating inconjunction with any other antenna or transmitter.IC statement (for DX-WGNBC)IC statementOperation is subject to the following two conditions: (1) This device maynot cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device.Important NoteIC Radiation Exposure Statement:This equipment complies with IC radiation exposure limits set forth foran uncontrolled environment. End users must follow the specificoperating instructions for satisfying RF exposure compliance. Thistransmitter must not be co-located or operating in conjunction with anyother antenna or transmitter.Legal notices© 2006 Dynex. DYNEX and the DYNEX logo are trademarks of Best BuyEnterprise Services, Inc. Other brands and product names are trademarksor registered trademarks of their respective holders. Specifications andfeatures are subject to change without notice or obligation.DX-WGNBC_WGDTC_combo.fm Page 7 Wednesday, June 21, 2006 11:53 PM