Dyson Airblade 1A Installation Instructions And Maintenance Manual

Contents

Dyson Airblade 1A Installation Instructions And Maintenance Manual Manual pdf 6 page image

5Looking after yourhand dryerPlease register as a Dysonhand dryer ownerTo help us ensure you receive a prompt andefficient service, please register your machineat www.dyson.com/airblade. This willregister your guarantee, confirm ownershipof your Dyson machine in the event of aninsurance loss, and enable us to contact youif necessary.You will need your serial number, which canbe found on the rating plate inside the mainbody and on the information sticker on thefront of the machine.Please ensure all instructions and guidance inthe Installation instructions and Maintenancemanual are adhered to or your guaranteemay be invalidated.MaintenanceHow to usePlace your hands beneath the DysonAirblade™ hand dryer arms and it will startautomatically, creating sheets of air thatscrape water from your hands.For best dry time results:Keep your hands flat and parallel to themachine's surface, approximately 5mm fromthe air aperture, drawing your hands throughthe airflow from your wrists to finger tips.Move your hands slowly through the airflow,keeping a consistent speed (approx.2.5 seconds per side), alternating betweenfront and back each time.Keep your hands flat, close the gaps betweenyour fingers and keep your thumbs tucked in,so the whole of your hand is drawn throughthe airflow.For more information about the powermodes, go to www.dyson.com/airbladeTroubleshootingHand dryer cuts outAfter 30 seconds of continued use the handdryer will turn off automatically. Remove andreplace hands to restart.Turn the machine off and on again at themains electricity supply.Make sure the sensors are clean.Check the air apertures are clean and free ofdust and blockages. If the air apertures aredusty, simply remove dust.Check that the air inlet is free from blockages.Dry time has increasedMake sure that the correct power mode hasbeen selected.Check that the air inlet is free from blockages.Inspect the air apertures for dust,and remove.Airflow is running hotterthan usualCheck that the air inlet is free from blockages.Inspect the air apertures for dust,and remove.Air is continuously runningAfter 30 seconds of continued use the handdryer will turn off automatically. Remove andreplace hands to restart.Check that the air inlet is free from blockages.Inspect the air apertures for dust,and remove.Contact Dyson for further supportand information or online atwww.dyson.com/airbladeCleaningThe hand dryer should be cleaned daily.Wipe the sensors using a soft cloth and non-abrasive cleaner.Important informationDon't pressure wash the machine.All cleaning chemicals should be usedexactly as indicated by the manufacturer’sinstructions (including appropriate dilution).Any chemicals intended for use should first betested on an inconspicuous area to confirmsuitability. Aside from cleaning chemicals,care should be taken to avoid any harmfulfluids from coming into contact with themachine, in particular oils and alcohol-based products.Filter maintenanceRegularly check the air inlet to ensure that it isfree from dust and debris. Simply wiping theinlet with a soft cloth should be sufficient toremove dust and debris.If the air inlet gets clogged, further cleaningor a filter change might be required.If required for high usage environments, aDyson filter change kit provides everythingneeded to change your machine’s HEPAfilter on site. Contact the Dyson Helpline formore information.Filter cleaning or replacement for your handdryer can be carried out by carefully followingthe instructions given in the filter change kit. Ifin any doubt, consult a qualified electrician orcontact the Dyson Helpline for support.ServicingIf your hand dryer needs servicing, pleasecall the Dyson Helpline or visit the website atwww.dyson.com/airblade