Dyson DC16 motorhead User Manual

Also see for DC16 motorhead: User guide User guide Manual

Contents

IIIIITroubleshootingIf flashing persists call the Dyson Helpline.In use ChargingIFully or partly charged.Fully discharged.Filter missing/Filter fitted incorrectly.Check/Refit Filter.orMachine outside of temperaturerange. Leave at room temperatureuntil flashing stops.Fully charged.Machine charging.Battery outside of temperature range.Remove from the charger and leave atroom temperature until red light nolonger flashes when placed in thecharger.orCharging fault. Remove appliance andrefit to the recharging unit.1 When using the appliance, the light on the handle indicates the level of charge. A green light indicates thebattery is fully or partly charged. A red light indicates the battery is fully discharged and needs charging.2 The battery will become hot during use – this is normal.3 The appliance will cut out immediately when the battery has run out – recharge for continued use.1 To ensure your appliance is always ready to use, store it on the charger.2 When connected to the charger, a red light indicates the battery is charging.A green light indicates the battery is fully or partly charged. Full charging takes around 3 hours.3 For optimum battery life always charge above 59°F, 15°C.Instructions1 When wall mounting the recharging unit, always use the appropriate fixings for your wall type.2 Check to ensure there is no pipework or wiring directly behind the mounting/drilling area.3 Fine dirt such as flour or plaster dust should only be vacuumed in very small amounts.4 Do not press down on the nozzle with excessive force when using the appliance, as this may cause damage.5 Ensure the appliance remains upright in use – do not hold upside down while vacuuming.6 If the motor overheats, the appliance will cut out automatically. Leave to cool down for at least an hourbefore restarting.