Dyson V6 Absolute Operating Instructions Manual

Also see for V6 Absolute: Operating manual Operating manual Operating manual Operating manual Operating manual

Contents

Dyson V6 Absolute Operating Instructions Manual Manual pdf 8 page image

81 2 3211 2 3876clickclick21Washing the brushbarsClearing brush bar obstructionsSoft roller cleaner head inStructionSlooking for blockageS• Ensure the appliance is disconnected from the charger before looking forblockages. Be careful not to pull the ‘ON’ trigger.• Do not operate while checking for blockages. Failure to do so could result inpersonal injury.• Beware of sharp objects when checking for blockages.• To gain access to blockages in the floor tool, remove the base plate by using acoin to loosen the screw marked with a padlock.• If you cannot clear an obstruction you may need to remove the brush bars,please refer to the ‘Washing the brush bars’ section for instructions on how todo this. Remove the obstruction and replace the brush bars as shown in the‘Washing the brush bars’ section. Ensure that the fastener is fully turned and thebase plate and brush bars are secure before operating the appliance.• This product has carbon fibre brushes. Take care if coming into contact withthem, as they may cause minor skin irritation. Wash your hands after handlingthe brushes.• Refit all parts securely before using.• Clearing blockages is not covered by your Dyson guarantee.WaShing the bruShbarS• Your appliance has two washable brush bars, check and wash these regularlyaccording to the following instructions to maintain performance.• Ensure the appliance is disconnected from the charger before removing thebrush bar. Be careful not to pull the 'ON' trigger.TO REMOVE, WASH AND REPLACE BRUSHBARS:• Please refer to the 'Washing the brush bars' illustrations alongside theinstructions below.• Turn the cleaner head upside down so the underside of the cleaner head isfacing you. Use a coin to turn the fastener one quarter anti-clockwise to theunlocked position.• Rotate the end cap to the open position. Gently slide the large brush bar awayfrom the cleaner head.• Remove the end cap from the large brush bar.• Lift out the small brush bar from the octagonal end and pull away from thecleaner head.• Hold the brush bars under running water and gently rub to remove any lintor dirt.• Stand both brush bars upright. Ensure the large brush bar is stood upright asshown. Leave to dry completely for a minimum of 24 hours.• Before replacing, check that the brush bars are completely dry. Refit the smallbrush bar before the large one. Insert the round end of the small brush bar intoplace. Push down the octagonal end until it clicks into place.• Reattach the end cap to the brush bar.• Slide the large brush bar back onto the cleaner head, around the motor. Theend cap should be in the open position as shown. Once in place, rotate the endcap back into the closed position.• Close the fastener by turning a quarter turn clockwise. Ensure that the fastener isfully turned and the brush bars are secure.