EAW UXA4403 Quick Start Manual
Also see for UXA4403: User manual
   |
One Main Street | Whitinsville, MA 01588 | Tel 800 992 5013 / 508 234 6158 | www.eaw.comEAW products are continually improved. All specifications are therefore subject to change without notice. ©2022 Eastern Acoustics WorksUXA4403 Quickstart GuideCarton Contents• Amplifier unit • Output connector x 1 or 2• Mains power cable • Adhesive rubber feet x 4• Input connector x 2 • Document pack• GPIO Socket Connector • Rack Mount Ears (fitted) x2Connection SocketsNetworkControlConfigurableGPIOS/PDIF Audio I/O Audio InputsBalanced: EuroblockUnbalanced: RCA Phono.ConfigurableSpeaker OutputsMainsPower InputWireless Network Control Connection Wired Network Control Connection• The amplifier must be switched on before use via its front panelStandby button. Do not switch on until all required signal and controlconnections are made.• High or low impedance speaker connection options can be selectedindependently for each output channel via the configuration webapp• Analogue input sensitivity can be adjusted independently for eachchannel via the configuration web app.Installation Notes• Audio I/O routing can be configured via the configuration web app.• GPIO (General Purpose Input/Output) options can be configured viathe configuration web app.• Ensure that rack or other confined installation does not restrictthe front to rear airflow required for safe and reliable operationof the amplifier. It is important that the 40°C maximum operatingtemperature for the amplifier is not exceeded.A mobile, laptop or desktop device with WiFi functionality and a webbrowser is required. Follow the steps below.1. Connect the [Amp Name] amplifier to mains power using thesupplied mains cable and switch it on via the front panel Standbyswitch. Wait for the front panel WiFi indicator to illuminate green.2. Use a mobile, laptop or desktop device to search for available WiFinetworks. Connect to, ‘[Amp Name] (product serial number)’ using thepassword, ‘password’. The amplifier serial number can be found on itsrear panel.3. Open a mobile, laptop or desktop device web browser and enterthe following IP address: 192.168.4.1. The amplifier configurationweb interface page will open in the browser app to enable amplifierconfiguration as required.It is strongly recommended that the amplifier WiFi password ischanged following initial wireless connection.A laptop or desktop device with Ethernet functionality, a web browserand a network scanning app is required. Follow the steps below.1. Connect the [Amp Name] amplifier Network Control socket directlyto a laptop or desktop device - or through a switch.2. Connect the [Amp Name] amplifier to mains power using thesupplied mains cable and and switch it on via the front panel Standbyswitch. Wait for the front panel Network indicator to illuminate greento indicate that the amplifier has network connectivity.3. The default LAN IP address of the amplifier is 192.168.64.100.Configure your laptop or desktop device to a fixed IP address in thesame IP range, ex. 192.168.64.10, with Subnet mask 255.255.255.0 (orprefix 24) and set Gateway to 192.168.64.1.4. Open a laptop or desktop device web browser and enter theaddress http://192.168.64.100/ - The amplifier configuration web pageinterface will open to enable amplifier configuration as required. |
Related manuals for EAW UXA4403
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine