EAW UXA4403D Quick Start Manual
   |
19 National Drive | Franklin, MA 02038 | Tel 800 992 5013 / 508 234 6158 | www.eaw.comEAW products are continually improved. All specifications are therefore subject to change without notice. ©2024 Eastern Acoustics WorksUXA4403D Quickstart GuideCarton Contents• Amplifier unit • Output connector x 1 or 2• Mains power cable • Adhesive rubber feet x 4• Input connector x 2 • Document pack• GPIO Socket Connector • Rack Mount Ears (fitted) x2Connection SocketsNetworkControlConfigurableGPIOS/PDIF Audio I/O Audio InputsBalanced: EuroblockUnbalanced: RCA Phono.ConfigurableSpeaker OutputsMainsPower InputWireless Network Control Connection Wired Network Control Connection• The amplifier must be switched on before use via its front panelStandby button. Do not switch on until all required signal and controlconnections are made.• High or low impedance speaker connection options can be selectedindependently for each output channel via the configuration webapp• Analog input sensitivity can be adjusted independently for eachchannel via the configuration web app.• Audio and DANTE I/O routing can be configured via theconfiguration web app.Installation Notes• GPIO (General Purpose Input/Output) options can be configured viathe configuration web app.• Ensure that rack or other confined installation does not restrictthe front to rear airflow required for safe and reliable operationof the amplifier. It is important that the 40°C maximum operatingtemperature for the amplifier is not exceeded.• Please ensure that QoS is configured on the network switch, as theDante port is enabled at 100Mbps link speed. More informationmay be found HEREA mobile, laptop or desktop device with WiFi functionality and a webbrowser is required. Follow the steps below.1. Connect the UXA4403D amplifier to mains power using the suppliedmains cable and switch it on via the front panel Standby switch. Waitfor the front panel WiFi indicator to illuminate green.2. Use a mobile, laptop or desktop device to search for available WiFinetworks. Connect to, UXA4403D (product serial number)’ using thepassword, ‘password’. The amplifier serial number can be found on itsrear panel.3. Open a mobile, laptop or desktop device web browser and enterthe following IP address: 192.168.4.1. The amplifier configurationweb interface page will open in the browser app to enable amplifierconfiguration as required.It is strongly recommended that the amplifier WiFi password ischanged following initial wireless connection.A laptop or desktop device with Ethernet functionality, a web browserand a network scanning app is required. Follow the steps below.1. Connect ethernet cable directly from computer to amp.2. Set computer ethernet to 192.168.64.99.3. Point browser to the amps default wired LAN address of192.168.64.100.4. Go to Settings, LAN, and change amp address to the desired IPaddress, subnet mask, gateway, and DNS.5. Hit Apply. The change only takes a few seconds.• Amp will disappear because it’s now on the other network.• If you have multiple amps to setup repeat steps 1-5 for eachamplifier you have one at a time.6. When finished with all amps, change your computer ethernetaddress to desired LAN IP address and all amps will show up. |
Related manuals for EAW UXA4403D
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine