ECD T90 Instruction Manual
                                                                           | |
Contents
| 
Page 51 Model T808.0 S80 SENSORSS80 sensors are a family of digital sensors designed for use with ECD digital analyzers, the Model T80 transmitteror the Model C80 controller. S80 sensors accept the standard ECD electrode cartridges. The S80 sensors convertthe analog signals into a temperature compensated digital protocol that allows two way communications withthe transmitter. The type of sensor, identity and serial number are stored in the sensor’s memory along withthree calibration registers. When connected to an ECD digital analyzer the sensor’s information is uploaded tothe analyzer configuring the displays and outputs to the values appropriate to the sensor’s measured parameter.Connect an S80 pH sensor to a Model T80 Transmitter and the Transmitter configures itself into a calibrated pHtransmitter.The internal components of the S80 sensors, the signal conditioner, temperature sensor and cable assembly areepoxy encapsulated inside the ¾” O.D. housing. Epoxy encapsulation of the components increases the reliabilityof the sensor by eliminating failures caused by wiring and connector breakage. The S80 sensors use the sameeasily replaceable electrode cartridges as the S10 and S17 sensor assemblies.8.1 S80 INSTALLATIONFour typical installation configurations are available for ECD sensors: insertion, immersion, flow-through andvalve-retraction. Although there are many ways to accomplish these mounting configurations, ECD recommendsthe following installation configurations.8.1.1 INSERTIONThe S80 sensor is installed using a ¾” MNPT compression fitting with choice of nylon, Teflon or 316 SS ferrule.The ¾” MNPT can be inserted into a pipe Tee or through a tank wall, the S80 is then inserted through the fittingand compression gland is tightened to secure the sensor in place. The torque specification for the gland fitting is20-ft/lbs. Over-tightening of the nut may swage the nylon or Teflon ferrules to the housing crushing the internalsensor components.8.1.2 IMMERSIONThe ¾” MNPT compression fitting is reversed and threaded into an extension/immersion pipe so thecompression gland is facing the measurement end of the sensor. Feed the cable through the immersion tube,insert the S80 sensor at least 5” into the tube and tighten the sensor in place.8.1.3 FLOW THROUGH |
Related manuals for ECD T90
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine