INSTALLATION INSTRUCTIONSHIGH PRESSURE PUMP WITH ELECTRIC MOTORMount the high pressure pump/motor unit to a cool location free of vibration.MEMBRANE HOUSINGMount the high-pressure membrane housing(s) with the provided brackets vertical(with the flow upwards) or horizontal in a convenient location away from the heat of the engine asclose as possible to the high pressure pump.The membrane is sealed within its housing by plugs at both ends. Inside is a small amount ofpreservative to keep the membrane moist and prevent bacterial growth.The shelf life of the preservative, under best conditions, is one year. We recommend you installand use your watermaker as soon as possible.When all other components and hoses/tubes are completely assembled, remove the caps on the highpressure fittings and the blue sealed tube from the product water outlet on the membrane housing/s andthen finish making all final hose/tube connections. This will insure that the membrane is kept moist.CONTROL PANELMount the control panel in an easily accessible location as close as possible to the membranehousing(s).SEA STRAINERMount the sea strainer with the provided 3/4" NPT nylon nipple directly to the intake of the 20 micronpre-filter housing. If an optional boost pump is required (refer to “Available Options andAccessories”), mount the sea strainer in a serviceable location in between the sea-cock and the boostpump. Connect the barbed fittings with the reinforced 3/4” vinyl hose. Secure the hose with thestainless steel hose clamps. Refer to the “Installation Instructions” (Optional).