xLogic SuperRelay User’s Manual202.2 Wiring the xLogicWire the xLogic using a screwdriver with a 3-mm blade.You do not need wire ferrules for the terminals. You can use conductors withcross-sections of up to the following thicknesses: 1 x 2.5 mm2 2 x 1.5 mm2 for each second terminal chamber Tightening torque: 0.4.. .0.5 N/m or 3. ..4 lbs/inNoteAlways cover the terminals after you have completed the i n s t a l l a t i o n . To p r o t e c tx Lo gi c a d e q u a t e l y f r o m impermissible contact to live parts, local standards must becomplied with.2.2.1 Connecting the power supplyThe ELC-18AC and ELC-12AC versions of ELC are suitable for operation with ratedvoltages of 110 V AC and 240 V AC. The ELC-18DC and ELC-12DC versions can beoperated with a 12 or 24 VDC power supply. For information on permissible voltagetolerances, line frequencies and power consumption, refer to the installation instructionsin the Product Information supplied with your device and to the technical data inAppendix A.NoteA power failure may cause an additional edge triggering signal.Data of the last uninterrupted cycle are stored in xLogic.To connect xLogic to the power supply:
