Eaton 600 A PUSH-OP Operation Instructions Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Contents

Eaton 600 A PUSH-OP Operation Instructions Manual Manual pdf 5 page image

Product informationIntroductionEaton's Cooper Power™ series 600 A, 15, 25, and 35 kVClass PUSH-OP™ deadbreak connector offers a completethreadless deadbreak, hotstick operable connection systemfor terminating underground cables to transformers,switches, switchgear, and other apparatus. It is fullyshielded, submersible, and meets the requirements of IEEEStd 386™-2006 standard - Separable Insulated ConnectorSystems. Service Information MN650011EN providesoperation instructions.read this manual firstRead and understand the contents of this manual and followall locally approved procedures and safety practices beforeinstalling or operating this equipment.additional informationThese instructions cannot cover all details or variationsin the equipment, procedures, or process described norprovide directions for meeting every possible contingencyduring installation, operation, or maintenance. For additionalinformation, contact your Eaton representative.Acceptance and initial inspectionEach PUSH-OP connector is in good condition whenaccepted by the carrier for shipment. Upon receipt, inspectthe shipping container for signs of damage. Unpack thePUSH-OP connector and inspect it thoroughly for damageincurred during shipment. If damage is discovered, file aclaim with the carrier immediately.Handling and storageBe careful during handling and storage of the PUSH-OPconnector to minimize the possibility of damage. If thePUSH-OP connector is to be stored for any length of timeprior to installation, provide a clean, dry storage area.StandardsISO 9001 Certified Quality Management Systemfigure 1. 600 a PuSH-oP connectorfigure 2. one-line diagram of a three-phase cable connected to a three-phase switch on either end.S1 S2WarNiNg600 a PuSH-oP connectors are designed to be operatedin accordance with normal safe operating procedures.these instructions are not intended to supersede orreplace existing safety and operating procedures.connectors must be de-energized during operation ormaintenance. Visible break and adequate groundingmust be provided before cable work proceeds. (Ensurethat the component is rated for the intended applicationbefore it is installed.)PuSH-oP connectors should be installed and servicedonly by personnel familiar with good safety practiceand the handling of high-voltage electrical equipment.failure to comply may result in death, severe personalinjury or equipment damage.1600 A PUSH-oP DeADbreAk connector oPerAtion inStrUctionS MN650011EN May 2017