Eaton 9E10000i Manual
                      |
Page 153.3.3 EBM W IRING CONNECTIONIt is possible to connect more than one EBM in order to achieve any level of autonomy without mains power. Connect any BatteryBoxes in a cascade as shown in the figure below:1. CONNECTION: Use 3 cables with 10 mm2 section (Earth, +, N and -)2. Connect the wires to the relative terminals, following exactly the instructions given below:For 9E6Ki, 9E10Ki, 9E10KiXLa - Make sure that the fuse holder of the external battery box is open.b - Connect the earth (PE) wire to EBM’s earth (PE) screwc - Connect the positive (+) branch wire to EBM’s positive (+) terminal.d - Connect the negative (-) branch wire to EBM’s negative (-) terminal.The suggested tighten force is 1.6Nm. (Detailed wiring diagram see fig 3-9~10)Versions 9E6Ki, 9E10Ki, 9E10KiXLNote: For 9E15Ki, 9E20Ki, 9E20KiXL EBM wiring connection, you should check the 9EEBM manual in EBMpackage.Fig.3-8 EBM terminal view (Fuse for 9E6Ki,9E10Ki, 9E10KiXLwithout Neutral)Fig.3-9 EBM terminal connection for 9E6Ki,9E10Ki, 9E10KiXL With Single EBMFig.3-10 EBM terminal connection for 9E6Ki,9E10Ki, 9E10KiXL With Mutliple EBM |
Related manuals for Eaton 9E10000i
manualsdatabase
Your AI-powered manual search engine