For more information visit: www.eaton.com IB ATS-1005Instructional BookletPage 2 Effective: March 2010 Instructions for Installation, Operation and Maintenance of theEaton ATC-600 Automatic Transfer Switch ControllerAll possible contingencies which may arise during installation,operation, or maintenance, and all details and variations of thisequipment do not purport to be covered by these instructions. Iffurther information is desired by purchaser regarding his particularinstallation, operation or maintenance of his equipment, the localEaton representative should be contacted.Section 1: Introduction1.1 Preliminary Comments and Safety PrecautionsThis technical document is intended to cover most aspects associ-ated with the installation, application, operation and maintenanceof the ATC-600. It is provided as a guide for authorized and quali-fied personnel only in the selection and application of the ATC-600. Please refer to the specific WARNING and CAUTION in Sec-tion 1.1.2 before proceeding. If further information is required bythe purchaser regarding a particular installation, application ormaintenance activity, a Eaton representative should be contacted.1.1.1 Warranty and Liability InformationNO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WAR-RANTIES OF FITNESS FOR A PARTICULAR PURPOSE OF MER-CHANTABILITY, OR WARRANTIES ARISING FROM COURSE OFDEALING OR USAGE OF TRADE, ARE MADE REGARDING THEINFORMATION, RECOMMENDATIONS AND DESCRIPTIONS CON-TAINED HEREIN. In no event will Eaton be responsible to the pur-chaser or user in contract, in tort (including negligence), strictliability or otherwise for any special, indirect, incidental or conse-quential damage or loss whatsoever, including but not limited todamage or loss of use of equipment, plant or power system, costof capital, loss of power, additional expenses in the use of existingpower facilities, or claims against the purchaser or user by its cus-tomers resulting from the use of the information and descriptionscontained herein.1.1.2 Safety PrecautionsAll safety codes, safety standards and/or regulations must bestrictly observed in the installation, operation and maintenance ofthis device.CAUTIONTHE ATC-600 IS FACTORY PROGRAMMED FOR A SPECIFIC TRANS-FER SWITCH. DO NOT ATTEMPT TO INTERCHANGE ATC-600 CON-TROL DEVICES WITHOUT CONSULTING THE FACTORY.NOTICEDURING CONVERSATIONS WITH EATON CONCERNING TROUBLE-SHOOTING OR PRODUCT RETURN, THE CUSTOMER MAY BE ASKEDFOR INFORMATION PERTAINING TO THE SOFTWARE VERSION ANDOPTIONS INCLUDED IN THE SPECIFIC UNIT. REFER TO THE “NOTE”UNDER THE TOPIC “HELP PUSHBUTTON” IN PARAGRAPH 3.4 FORINSTRUCTIONS ON HOW TO OBTAIN THIS INFORMATION.WARNINGTHE WARNINGS AND CAUTIONS INCLUDED AS PART OF THE PRO-CEDURAL STEPS IN THIS DOCUMENT ARE FOR PERSONNEL SAFETYAND PROTECTION OF EQUIPMENT FROM DAMAGE. AN EXAMPLEOF A TYPICAL WARNING LABEL HEADING IS SHOWN IN REVERSETYPE TO FAMILIARIZE PERSONNEL WITH THE STYLE OF PRESENTA-TION. THIS WILL HELP TO INSURE THAT PERSONNEL ARE ALERT TOWARNINGS, WHICH MAY APPEAR THROUGHOUT THE DOCUMENT.IN ADDITION, CAUTIONS ARE ALL UPPER CASE AND BOLDFACE ASSHOWN BELOW.CAUTIONCOMPLETELY READ AND UNDERSTAND THE MATERIAL PRE-SENTED IN THIS DOCUMENT BEFORE ATTEMPTING INSTALLATION,OPERATION OR APPLICATION OF THE EQUIPMENT. IN ADDITION,ONLY QUALIFIED PERSONS SHOULD BE PERMITTED TO PERFORMANY WORK ASSOCIATED WITH THE EQUIPMENT. ANY WIRINGINSTRUCTIONS PRESENTED IN THIS DOCUMENT MUST BE FOL-LOWED PRECISELY. FAILURE TO DO SO COULD CAUSE PERMA-NENT EQUIPMENT DAMAGE.