Eaton Activeline GH5 Technical Manual

4GH5 Activeline B e a c o n TechnicalManualGH5 ACTIVELINE BEACON TECHNICAL MANUAL TMF0075.A www.eaton.comCE symbolWe hereby declare this product is in compliance with the Essential Health and Safety Requirements ofATEX Directive 2014/34/EU,EMC Directive 2014/30/EU,Low Voltage Directive 2014/35/EU and RoHS Directive 2011/65/EU.The appropriate standards, technical regulations und specifications you can take from the attached conformity declarationand the conformity declarations on our Website.ø 8,526135185 103 120268300315[mm]Multicolour Light GH5 DimensionsApplicationThe ActiveLine Multicolour Light GH5 is designed as a fixed device of equipment group II category 3 for use in areas thatcan rarely and at short notice be endangered by an explosive atmosphere. The Multicolour Light GH5 is constructed foruse in zone 2 and 22. The light is an optical signalling de vice for universal use. The possible signalling colours red, yellow,green, blue and white serve many different signalling functions. The different signalling colours are generated in onesingle light element. Every colour allows presetting one of the operating modes: continuous light, signalling light or flashlight. The light is generated by light-emitting diodes.ConstructionThe plastic enclosure and the cap consist of impact resistant polycarbonate. The metal bracket is intended for wallmounting.MountingThe device may be placed in any position. The mounting angle can be rotated 90°, requiring you to loosen the 4 hexagonsocket screws using a 4 mm Allen key, rotating the mounting angle in the desired position, inserting the screws andtightening them. The device is fastened with 2 screws (ø 6...8 mm) on the wall/ceiling.Care and maintenanceThe strobe light contains no serviceable parts. The requirements of EN 60079-17 regarding the regular control of theexplosion protection must be applied.X Protection against mechanical impactThe device should be positioned in such a way that mechanical damage, e.g. due to falling parts or lateral impact isprevented.Notes on cable gland and cable entry1. Ambient operating temperature: Ta: -20°C to +50°C2. Thread diameter: Ø M20 x 1.53. Housing degree of protection: IP 664. Type of protection: Ex e II5. Use only suited tools for installing the cable glands.6. The cable gland is suited for permanent wiring only.7. In case of factory fitted cable glands the attached operating instructions have to be considered.