Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manual

Also see for BreakerVisu NZM-XMC-MDISP35-MOD: Manual Instruction leaflet Instruction leaflet Instruction leaflet

ContentsNZM-XMC-MDISP... 02/2016 MN048013 EN www.eaton.eu 1Contents0 About this manual ..................................................................... 30.1 Target group................................................................................. 30.2 Additional documentation ............................................................ 30.3 Writing conventions ..................................................................... 40.3.1 Hazard warnings of material damages ......................................... 40.3.2 Hazard warnings of personal injury .............................................. 40.3.3 Tips............................................................................................... 41 Description of device ................................................................. 51.1 Supported devices ....................................................................... 51.2 Device models ............................................................................. 61.3 Topology....................................................................................... 71.4 Wiring diagram ............................................................................. 81.4.1 Terminal markings........................................................................ 91.5 Equipment supplied ..................................................................... 101.5.1 3.5“ devices ................................................................................. 101.5.2 7.0“ device................................................................................... 101.6 Nameplate.................................................................................... 101.7 Maintenance and inspection ........................................................ 101.7.1 Cleaning the resistive touchscreen .............................................. 111.7.2 Recalibrating the resistive touchscreen ....................................... 111.7.3 Battery.......................................................................................... 111.8 Repair ........................................................................................... 111.9 Storage......................................................................................... 111.10 Transport ...................................................................................... 111.11 Service and warranty.................................................................... 121.12 Disposal........................................................................................ 121.13 Device-specific hazards................................................................ 132 Installation .................................................................................. 152.1 Area of application........................................................................ 152.2 Underwriters Laboratories Inc. (UL) requirements....................... 152.3 Installation position ...................................................................... 152.4 Interfaces ..................................................................................... 172.4.1 Preparing the cables with the SUB-D plug................................... 192.4.2 Power supply ............................................................................... 202.4.3 Ethernet ....................................................................................... 222.4.4 USB device................................................................................... 232.4.5 USB Host ..................................................................................... 232.4.6 SmartWire-DT master .................................................................. 232.4.7 POW/AUX (power supply for SmartWire-DT)............................... 242.4.8 RS485........................................................................................... 282.5 Mounting...................................................................................... 302.5.1 Mounting the device .................................................................... 313 Operation .................................................................................... 333.1 Start Device.................................................................................. 33