Intelligent Technologies QCPort System Install ManualNovember 2005MN05001002E For more information visit www.eatonelectrical.com Page 7Examples of QCPort UseOne Device Using QCPortIn many applications, the QCPort will be used as the connection between a motorcontroller and the user interface/configuration keypad. The following figure contains aone-to-one solution, where the user interface is powered from the motor controller’sQCPort. A separate power supply is not required for the user interface. In this example,the user interface is connected to Channel 0 of the motor controller. Channel 0 isspecifically used for connection to the user interface and operator stations.Figure 1: Example of One Device Using QCPortThe interconnect supplied with the operator interface connects the operator interface tothe motor controller. This connection provides for 24V DC and communication; theoperator interface is powered from the motor controller. Configuration of the operatorinterface or the motor controller for this application is not required for communication tobe established. The user can then use the operator interface to configure the motorcontroller parameters, operate the motor controller, and monitor the operation of themotor controller.The information contained within this manual does not include instructions for setup oroperation of the motor controller or operator interface. For instructions on how to applythe operator interface, refer to the manual for that device.