Eaton Cutler-Hammer PanelMate 3000 Series Manual
         |
Cutout TemplateCare should be taken when tightening thenuts. The fasteners must be tightenedenough to obtain a proper seal, but not overtightened to the point where the threads arestripped or the gasket is rendered useless.Always use a torque wrench when installingyour PanelMate unit. Torque Limits for Studs7 inch-pounds for #8-32 nutsDimensions are in inches.Millimeter dimensions are in parentheses.Notes:.22 Dia. Slot.22 Dia. Hole11.4011.015.875.875.705.705.705.484.504.505.535.704.651.55 1.554.65(5.59)(5.59)(289.56)(279.65)(149.10)(149.10)(144.78)(144.78)(139.19)(114.30)(114.30)(140.46)(144.78)(118.11)(39.37) (39.37)(118.11)(144.78)Cutout1.501.50(38.10)(38.10)This drawing is not 1:1 scale. Please refer to theExpress Setup Sheet included with yourPanelMate unit for a 1:1 cutout drawing. |
Related manuals for Eaton Cutler-Hammer PanelMate 3000 Series
Eaton Cutler-Hammer PanelMate Manual
Eaton Cutler-Hammer PanelMate 500 Series Getting Started User Manual
Eaton PanelMate 5000 Series Express Set-up Manual
Eaton XV300 Series Manual
Eaton 4200 Series User Manual
Eaton Cuttler-Hammer FDAP-M Operation Manual
Eaton E Series Troubleshooting Manual
Eaton Cooper Power Series Installation Instructions Manual
Eaton JSB FX4200 Series Installation Instructions Manual
Eaton EFCV8ZONE User Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine