Eaton ET1187 Operator's Manual

Contents

4EATON ET1187 Operating Instructions E-EQCR-11001-E1 November 2018OperatingInstructionsEstablishing Crimp Settings (Same procedure utilized for both Core and Winner Product Groups)Install FT1380-200-XXX Die Cageper crimp die chart on the front of themachine.Step 1:Reference the crimp specification charton the front of the crimp machine todetemine proper crimp dies for hoseand fitting.Step 2:Rotate hose product selection collar un-til desired product group is facing opera-tor. Note: Collar has detents at eachposition to help ensure proper alignmentwith corresponding product groups.Crimp Procedures(using FT1380-200-MXXX Series Die CagesStep 3:The color coded collar and crimp adjustment knob above the pusher is designed to easily adjust to the Aeroquip and Weath-erhead core products to determine the crimp diameter for each combination of hose, fitting, and die cage (See below). Simplyturn the collar to the correct color to match the lay line on the hose, adjust the ring so that the correct size dot aligns with thecorrect size line on the collar and the machine is set for the correct crimp. Load the correct crimp die based on the crimp diechart attached to the machine, and the machine is ready to crimp.The micrometer section can be used to crimp other products not captured on the 3 primary collar settings, based on crimptarget settings available in PowerSource.GH781 / H280Standard machine comeswith GH781/H280 settingsbuilt in for use with TTC/Zfittings in sizes -4 through-20.GH493 / H430Standard machine comeswith GH493/H430 set-tings built in for use withTTC12/4S fittings in sizes -6through -10, and 4S fittingsin sizes -12 and -16.Micrometer DialThe micrometer section canbe used to crimp otherproducts not captured onthe 3 primary collar settings,based on crimp target set-tings available in Power-Source.GH681 / H180Standard machine comeswith GH681/H180 settingsbuilt in for use with TTC/Z fit-tings in sizes -4 through -20.-12 size setting shown -8 size setting shown -16 size setting shown