Eaton Edison Cooper Power Series Installation And Operation Instructions Manual

Contents

5Edison™ Single-Phase Vacuum Capacitor SwitchInstallatIon and operatIon InstructIons MN230007EN February 2017Switch operationElectrical operationThe switch may be opened and closed electrically byapplying rated control voltage to the proper terminals ofthe actuator receptacle. See “Installation procedure” onpage 3 for electrical connections and operating time.Manual hotstick operationWARNINGHazardous voltage This device is not a substitute fora visible disconnect Follow all locally approved safetypractices Failure to follow proper safety practices canresult in contact with high voltage, which will causedeath or severe personal injury G112 1The switch may be manually opened by using a hotstick tooperate the yellow manual operating handle under the sleethood as shown in Figure 3 and Figure 4.WARNINGHazardous voltage Do not rely on the open position ofthe yellow operating handle; it does not ensure that theline has been de-energized Always establish a visibledisconnect Failure to follow proper safety practices canresult in contact with high voltage, which will causedeath or severe personal injury G116 0To open the switch contacts, insert the hotstick tip intothe hotstick guide of the manual operating handle and pulldownward to the OPEN position. See Figure 3.Control power is required to close the switch.Contact position indicationThe yellow operating handle is also used as a contactposition indicator. The switch is closed when the operatinghandle is in the up position and is open when the operatinghandle is in the down position. See Figure 3 and Figure 4.Figure 3 Contact position indicator (switch shown inclosed position)Figure 4 Contact position indicator (switch shown inopen position)

/ 12

Related manuals for Eaton Edison Cooper Power Series