Eaton FT1380e Start-up
Also see for FT1380e: Operator's manual
  |
WARNING: Failure to follow Eaton process and product instructions andlimitations could lead to premature hose assembly failures, resulting in propertydamage, serious injury or death. Read and understand the operator’s manualbefore attempting to operate any equipment.LIFTING INSTRUCTIONS: Place pallet on level surface prior to unbolting.Gloves are recommended for the unbolting process. Lag bolts are located ateach of the 4 corners of the machine base. Remove the lag bolts using a ½”open end wrench or socket. Be careful when lifting machine so that it does nottip over. Do not lift by hand. When moving the machine, secure the crimper to aforklift. Any straps used to aid in the lifting process should not be placed aroundthe electrical box, which is positioned on the left side of the crimp machine.SETUP AND INSTALLATION:1. Mount your Eaton FT1380e crimp machine onto a stable work surface that will support at least 300 pounds.Secure the unit using the holes provided in the corners of the crimp machine base.*Ensure crimp machine placement allows adequate access to the electrical box per OSHA and local regulations.CRIMP MACHINE DIMENSIONSWidth: 16.062 inches Depth: 25.75 inches Height: 29.875 inches Weight: 222 pounds2. Remove the plug from the hydraulic reservoir vent port and replace it with the vent cap that is supplied with the unit.CAUTION: Failure to do so will cause cavitation and damage to the pumping mechanism. Hand tighten the vent cap.The FT1380e machine comes pre-filled with Hydraulic Oil. The MSDS can be found at eatoncrimpersupport.com.3. Plug the machine into a dedicated outlet. Never use an extension cord, always plug directly into the power outlet.CAUTION: Provide electrical service with a dedicated circuit (per the crimp machine electrical requirements) toeliminate the possibility of a low-voltage situation.ELECTRICAL REQUIREMENTS:FT1380e-115, FT1380e-115CSA:115-Volt AC single phase (50/60) Hz Circuit with a minimum of 20 ampsFT1380e-230, FT1380e-230CSA:208 to 230-Volt AC single phase (50/60) Hz Circuit with a minimum of 15 ampsEaton FT1380eElectronic crimp machine start-up sheetSEE BACK FOR OPERATOR’S INSTRUCTIONS |
Related manuals for Eaton FT1380e
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine