INS #Installation InstructionsModel# LK8-NOModel# LK8-LRCModel# LK8-MRCModel# LK8-TPRCLiteKeeper® 8General InformationThe LiteKeeper 8® is shipped in one package. The relaycard is mounted in the high voltage compartment. Thelogic board and inputs are located in the low voltagecompartment. The following information describes theLiteKeeper® installation. For programming information,refer to the LiteKeeper® Programming Manual.Getting Started1. Do not discard these installation instructions. Pleasekeep for future reference and operation information.2. The relay cards are protected by shrink-wrap. Leaveshrink-wrap in place until all drilling and metal work iscomplete to protect against metal shards getting intocomponent circuitry.3. Always disconnect all power before wiring.4. Use only as intended and at the listed voltage.5. All installation service must be performed by qualifiedpersonnel or service technicians.6. Install in accordance with National Electrical Codeand any other codes that may apply.7. High Voltage is present inside the lighting enclosure.Use extreme caution when performing maintenanceon this equipment. Failure to follow this warning andproper safety procedures could result in severe injuryor death and/or damage to the equipment.8. Document all wiring that is terminated to the relaysso that the lighting control equipment can be properlyconfigured and programmed for operation.9. It is recommended that all low voltage wiring bedone with power removed to the logic board toprotect components from potential shorts during thewiring process.Mounting in the Enclosure1. Choose a dry location convenient to the circuitbreaker panel.2. Mount the panel on a firm surface using pre-drilledholes.3. Connect the enclosure to the circuit breaker panelusing conduit into the punch holes provided.4. Remove all cuttings and dirt before removingshrink-wrap from the relays.otte:N Make certain that high voltage and low voltagewiring enters the enclosure separately. HighVoltage wiring should be brought into the top orbottom of the enclosure. Low Voltage wire shouldenter in the low voltage wiring compartment onthe left side of the enclosure.Failure to separate high voltage from low voltage wiringmay cause interference with logic board function.DCGND+24VDCTB1TB18OFF+24HONC21+24OFFH1ONC0* # D5812:OO O1/O1/95247OUTPUTSRELAY65438716 B9 C3 AOFF+24H1ONCOFF+24H1ONCOFF+24H1ONCOFF+24H1ONCOFF+24H1ONCOFF+24H1ONCLow and High VoltageLow Voltage WiringCompartmentLITEKEEPERHigh Voltage WiringCompartment